IMPORTANT SAFETY INSTRUCTIONS
In these safety instructions the word “product” refers to the Canon Digital Video Camcorder
1.Read Instructions — All the safety and operating instructions should be read before the product is operated.
2.Retain Instructions — The safety and operating instructions should be retained for future reference.
3.Heed Warnings — All warnings on the product and in the operating instructions should be adhered to.
4.Follow Instructions — All operating and maintenance instructions should be followed.
5.Cleaning — Unplug this product from the wall outlet before cleaning. Do not use liquid or aerosol cleaners. The product should be cleaned only as recommended in this manual.
6.Accessories — Do not use accessories not recommended in this manual as they may be hazardous.
7.Avoid magnetic or electric fields — Do not use the camera close to TV transmitters, portable communication devices or other sources of electric or magnetic radiation. They may cause picture interference, or permanently damage the camera.
8.Water and Moisture — Hazard of electric shock — Do not use this product near water or in rainy/moist situations.
9.Placing or Moving — Do not place on an unstable cart, stand, tripod, bracket or table. The product may fall, causing serious injury to a child or adult, and serious damage to the product.
A product and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the product and cart combination to overturn.
10.Power Sources — The
11.Polarization — The
12.Power Cord Protection — Power cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them. Pay particular attention to plugs and the point from which the cords exit the product.
13.Outdoor Antenna Grounding — If an outside antenna is connected to the product, be sure the antenna is grounded so as to provide some protection against voltage surges and
Fig. 1 | EXAMPLE OF ANTENNA GROUNDING AS |
PER NATIONAL ELECTRICAL CODE | |
| ANTENNA |
| LEAD IN |
| WIRE |
| GROUND |
| CLAMP |
| ANTENNA |
| DISCHARGE |
| UNIT |
| (NEC SECTION |
| |
ELECTRIC |
|
SERVICE |
|
EQUIPMENT | GROUNDING CONDUCTORS |
| (NEC SECTION |
| GROUND CLAMPS |
| POWER SERVICE |
| GROUNDING ELECTRODE |
| SYSTEM |
| (NEC ART 250. PART H) |
NEC - NATIONAL ELECTRICAL CODE
14.Lightning — For added protection of this product during a lightning storm, or when it is left unattended and unused for long periods of time, disconnect it from the wall outlet and disconnect the antenna. This will prevent damage to the product due to lightning and
15.Power Lines — An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.
16.Overloading — Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.
17.Objects and Liquid Entry — Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Be careful not to spill liquid of any kind onto the product.
18.Servicing — Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
E
Introduction
3