Canon HV20 Analog/Digital Conversion, Copyright Signal, Converting the Video, Connected devices

Recording starts.

7While recording, press / to pause the recording.

In record pause, press / again to resume recording.

8Press to stop recording.

9Connected device: Stop the playback.

IMPORTANT

Blank sections may be recorded as anomalous picture.

If the picture does not appear, disconnect the DV cable and restore the connection after a short while or turn the camcorder off and then on again.

Do not connect any devices to the camcorder’s USB terminal while an external device is connected to the HDV/DV terminal.

You can only record video signals in HDV standard (1080i specifications) or in DV standard. Note that signals from identically shaped DV (IEEE1394) terminals may be in different video standards.

NOTES

We recommend powering the camcorder using the compact power adapter.

Copyright Signal

Certain software tapes are copyright protected. If you attempt to play back such tapes, “COPYRIGHT PROTECTED PLAYBACK IS RESTRICTED” appears and you will not be able to view the contents of the tape. If you attempt to record from such tapes via the HDV/DV terminal,

“COPYRIGHT PROTECTED DUBBING RESTRICTED” appears and you will not be able to record the contents of the tape.

Connecting to a TV or VCR 73

Analog/Digital Conversion

Using the camcorder you can convert analog video signals (for example from a VCR) to digital signals (DV standard only) and output them to a digital recording device.

( 10)

Connecting

Connect the camcorder to the video input source using an analog connection –connection type 4 ( 66)– shown in the previous section Connection Diagrams.

Connect the camcorder to the recording device using the digital connection –connection type 2 ( 66)– shown in the same section. Verify that the DV terminal on the external digital device is compatible with the DV standard.

Converting the Video

FUNC.

( 23)

1Set [AV DV] to [ ON] ( 39).

2Start the playback on the video

source and the recording on the
recording device.			External
Refer to the instruction manuals of the
connected devices.
IMPORTANT			Connections
Depending on the signal sent from the
connected device, the conversion from analog
to digital signals might not work properly (e.g.,
signals that include copyright protective signals
or anomalous signals such as ghost signals).
Usually, leave [AV DV] set to the default
setting [	OFF]. While it is set to [	ON],

you cannot connect video input signals to the camcorder using the HDV/DV terminal.