Rogue Audio Tempest Vacuum Tube Integrated Amplifier owner manual KT88 12AU7 12AX7

Page 5

4)Install Power Tubes - To avoid damage in transit, the power tubes are shipped in a protective container inside the main shipping container. Carefully unpack the tubes, and using a glove or a clean dry cloth, install the tubes as shown in figure 1.

KT88

KT88

12AU7

12AU7

12AX7

12AX7

12AU7

12AU7

Figure 3

Note that amps may be shipped with a different but equivalent tube

5)Inspect Input and Driver Tubes - Inspect the remaining tubes to ensure that they are fully seated in their ceramic sockets. If a tube appears to be tilted or otherwise dislocated, using a glove or clean cloth, press down gently on the tube to re-seat it in its socket. See Figure 3 for tube locations.

Rogue Tempest Owners Manual

3

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Vacuum Tube Amplifiers Table of Contents Introduction Setting UP Your AmplifierPage KT88 12AU7 12AX7 Ultra-Linear Ohm Binding Wire Feedback Post Using AN External Preamplifier External Operating Your Tempest Replace Tubes by MaintenanceIf Sound is not Present or is only in ONE Channel If There is a ProblemOwner and Warranty Registration Form Adding a Rogue EIGHTY-EIGHT Power AMPTHD SpecificationsWarranty Period Limited WarrantyRogue Audio Inc Avery Road Slatington, PA
Top Page Image Contents