Rogue Audio Tempest Vacuum Tube Integrated Amplifier Adding a Rogue EIGHTY-EIGHT Power AMP

Page 13

ADDING A ROGUE EIGHTY-EIGHT POWER AMP

One of the features of the Tempest is that a Rogue Eighty-Eight power amplifier can be added at a later date to increase the system power. It is important to use a Rogue Eighty-Eight amplifier so that the power levels are equivalent between the two amplifiers for a given input signal. It is also required that the speakers are capable of being biamped (Separate inputs for tweeters and woofers) The procedure for biamping is as follows:

1)Remove the shorting connection on the speakers between the tweeter and woofer inputs.

2)Attach the Speaker wires from the Tempest to the tweeter connectors on the loudspeakers.

3)Attach speaker cables from the Eighty-Eight amp to the woofer connectors on the loudspeakers.

4)Connect the active outputs of the Tempest to the inputs of the Eighty-Eight amp.

OWNER AND WARRANTY REGISTRATION FORM

Included with this manual is an Owner and Warranty Registration Form. Please take a minute to fill out this card and return it Rogue Audio.

Rogue Tempest Owners Manual

11

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Vacuum Tube Amplifiers Table of Contents Introduction Setting UP Your AmplifierPage KT88 12AU7 12AX7 Ultra-Linear Ohm Binding Wire Feedback Post Using AN External Preamplifier External Operating Your Tempest Replace Tubes by MaintenanceIf Sound is not Present or is only in ONE Channel If There is a ProblemOwner and Warranty Registration Form Adding a Rogue EIGHTY-EIGHT Power AMPTHD SpecificationsWarranty Period Limited WarrantyRogue Audio Inc Avery Road Slatington, PA
Top Page Image Contents