Madrigal Imaging N380S owner manual Setup and Installation

connections and cables

Note:

Setup and Installation

The Nº380S incorporates both RCA-type and XLR-type connectors for audio sig- nal input and output.

The Madrigal-designed RCA-type connectors used for single-ended audio intercon- nection are a great improvement over ordinary RCA-type connectors, offering supe- rior contact integrity and mechanical locking when used in conjunction with the Madrigal cable-mounted RCAs. The gold-plated XLR-type connectors used for bal- anced connections are made to professional application standards.

When connecting the Nº380S to source equipment and power amplifiers, we rec- ommend Madrigal Audio Laboratories CZ Gel Interconnect Cable. CZ Gel is avail- able in various lengths, in purpose-designed balanced and single-ended configu- rations. See your Mark Levinson dealer for more information.

Connect the AC cord to the male IEC connector on the center of the bottom panel of the Nº380S, then connect the AC cord to the AC mains.

To Nº380S To AC mains

			1	= Line (hot)
1 2	1	2	2	= Neutral
			3	= Earth ground
3		3

When power is first applied to the Nº380S, the preamp will run through an auto- matic initialization sequence which (among other things) provides a “role-call” of the current input names (see “Names” on the next page), selects the first name other than NOT USED or ssp, and sets the volume to OFF.

For optimal sonic performance and longevity, the Nº380S is designed to remain powered at all times (the standby switch merely mutes the preamplifier’s outputs and turns off the display). There is an initial break-in period of approximately 300 hours before the Nº380S achieves optimum performance.

If AC mains power to the Nº380S is interrupted, the main output will be muted. When power is restored, the initialization sequence described above will restore the preamplifier to normal operation, with the main output muted and the display indicating OFF.

We recommend you allow the circuitry within your various system components to stabilize for 1 to 2 minutes before use after such a power outage.

18