Madrigal Imaging N380S owner manual If the Source in Question is a Recordable DEVICE…

Page 21

assigning record outputs

5IF THE SOURCE IN QUESTION IS A RECORDABLE DEVICE…

You will be further prompted to associate a particular record output with this particular device. Instead of showing “NEW DATA,” the display will read “RCD: NONE” as shown below.

You may elect not to use either record output with this particular device, as may be the case if you have several devices in your system that are capable of recording. In this case, leave the display on “RCD: NONE” and move to Step 6.

You may also select either record output 1 or 2 to be associated with this particular input. To do so, press the input button repeatedly until you see your choice of OUT1 or OUT2 in the display. (OUT1 is given as an example below.)

6STORE YOUR SELECTION

Save your choice in nonvolatile memory by pressing and holding the Mode button until the display reads NEW DATA, as below.

21

Image 21
Contents Nº380S Preamplifier Page Important Safety Instructions Page Table of Contents Unpacking and Placement Operating Voltage Quick Start… Front Panel Mode Indicators Standby Button Rear Panel Male RCA Male XLR Record Outputs External IR Input Remote Control Mute Setup and Installation Not Used any unused input Until the Name you desire appears in the display If the Source in Question is a Recordable DEVICE… Decide Which Source has the Highest Output Press and Hold the Mode Button on the Front Panel This will be the preferred, programmed level Press and Hold the Mute Button Adjust the Volume Knob to Your Preferred Setting Display will NOW Time OUT and Return to Normal Operational Modes Balance mode Balance control tip Using Surround Sound Processors SSP must not be in a tape loop Ground Isolation Adaptor Linked Functions Care and Maintenance Canadian Warranty Obtaining Service Inputs SpecificationsDimensions Madrigal Audio Laboratories