Madrigal Imaging N380S owner manual Specifications, Inputs

Page 38

Specifications

The correlation between published specifications and sonic quality is unreliable. A list of numbers reveals virtually nothing. All technical measurements must be sub- ject to qualitative as well as quantitative interpretation.

Measurements of the Nº380S yield excellent results by any standards. However, only those specifications that apply to its actual operation are included here.

■ Power consumption:

40W maximum

■Mains voltage: 100V, 120V, 200V, 220V, or 240VAC @ 50/60Hz

■

Overall dimensions:

See “Dimensions”

■

Shipping weight:

35 lbs. (16 kg)

■

Inputs:

2 stereo balanced (Swiss XLR female)

 

 

4 stereo single-ended (Madrigal RCA female)

 

 

1 Mark Levinson Link communications connector

 

 

1 1⁄8" mini-jack for external IR repeater

■Outputs:2 stereo record outputs (Madrigal RCA female) 1 stereo balanced main out (Swiss XLR male)

1 stereo single-ended main out (Madrigal RCA female) 1 Mark Levinson Link communications connector

■Gain:

■ Gain range:

-72.1 dB to +18.9 dB

■Gain resolution:0.1 dB steps above 38.8 in display (-34 dB), gradually increasing step size at lower levels

■

Input overload:

greater than 16V (0 dB output)

■

Input impedance:

100kΩ shunted by 220pF

■

Output impedance:

less than 6Ω

■ Maximum output (MAIN outputs):

16V rms, balanced

For more information, see your Mark Levinson dealer, or contact:

Madrigal Audio Laboratories, Inc.

P. O. Box 781

2081 South Main Street

Middletown, Connecticut 06457 USA

Phone

(860)

346-0896

FAX

(860)

346-1540

WWW

http://www.madrigal.com

38

Page 37 Page 39
Image 38
Page 37 Page 39
Contents Nº380S Preamplifier Page Important Safety Instructions Page Table of Contents Unpacking and Placement Operating Voltage Quick Start… Front Panel Mode Indicators Standby Button Rear Panel Male RCA Male XLR Record Outputs External IR Input Remote Control Mute Setup and Installation Not Used any unused input Until the Name you desire appears in the display If the Source in Question is a Recordable DEVICE… Decide Which Source has the Highest Output Press and Hold the Mode Button on the Front Panel This will be the preferred, programmed level Press and Hold the Mute Button Adjust the Volume Knob to Your Preferred Setting Display will NOW Time OUT and Return to Normal Operational Modes Balance mode Balance control tip Using Surround Sound Processors SSP must not be in a tape loop Ground Isolation Adaptor Linked Functions Care and Maintenance Canadian Warranty Obtaining Service Specifications InputsDimensions Madrigal Audio Laboratories
Top Page Image Contents