Madrigal Imaging N380 manual Display will NOW Time OUT and Return to Normal

Page 27

standby timer

mal volume mode of operation. The display will read LOCK OFF to indicate the return to normal operation.

In a similar fashion, you may elect to have the preamplifier (and the entire sys- tem, if Linked) go into standby after a certain period of time, much like a “Sleep Timer” on many alarm clocks. To engage the standby timer on the Nº380:

1.PRESS AND HOLD THE STANDBY BUTTON UNTIL THE DISPLAY READS TIME OFF.

2.TURN THE VOLUME KNOB TO SELECT A TIME BETWEEN 1 AND 120 MIN- UTES.

An example might be: TIME 60 would turn off the system in an hour.

3.THE DISPLAY WILL NOW TIME OUT AND RETURN TO NORMAL

The preamp (or entire Linked system) will go into standby at the appointed time one time only (so you don’t have to live with the product turning itself off every 60 minutes thereafter…).

27

Image 27

Contents Operating Manual Page Important Safety Instructions Page Table of Contents Unpacking and Placement Operating Voltage Quick Start… Front Panel Mode Indicators Standby Button Preamplifier Nº380 Rear PanelMale RCA Male XLR Connect to source Record Outputs External IR Input Remote Control Mute Setup and Installation Not Used any unused input Until the Name you desire appears in the display If the Source in Question is a Recordable DEVICE… Decide Which Source has the Highest Output Press and Hold the Mode Button on the Front Panel This will be the preferred, programmed level Press and Hold the Mute Button Adjust the Volume Knob to Your Preferred Setting Display will NOW Time OUT and Return to Normal Operational Modes Balance mode Balance control tip Using Surround Sound Processors SSP must not be in a tape loop Ground Isolation Adaptor Linked Functions Care and Maintenance Canadian Warranty Obtaining Service Inputs SpecificationsDimensions Madrigal Audio Laboratories