Madrigal Imaging N380 manual Operating Voltage

Page 7

Operating Voltage

The Nº380 Preamplifier is set at the factory (internally) for 100V, 120V, 200V, 230V, 220V, or 240V AC mains operation @ 50 or 60Hz. (230V/50Hz only in European Union countries, in compliance with CE regulations.) This voltage setting cannot be changed by the user.

Make sure that the label on the bottom panel of the Nº380 (adjacent to the AC cord) indicates the correct AC operating voltage for your location.

If the voltage indicated on your Nº380 is incorrect, or if you wish to change the AC operating voltage of your Nº380 as the result of moving to a different country than the one in which you purchased your digital audio processor, see your Mark Levinson dealer.

The Nº380 is easily powered by a normal 15-ampere AC mains line. If other de- vices are also powered from the same AC line, their additional power consump- tion should be taken into account.

7

Image 7

Contents Operating Manual Page Important Safety Instructions Page Table of Contents Unpacking and Placement Operating Voltage Quick Start… Front Panel Mode Indicators Standby Button Preamplifier Nº380 Rear PanelMale RCA Male XLR Connect to source Record Outputs External IR Input Remote Control Mute Setup and Installation Not Used any unused input Until the Name you desire appears in the display If the Source in Question is a Recordable DEVICE… Decide Which Source has the Highest Output Press and Hold the Mode Button on the Front Panel This will be the preferred, programmed level Press and Hold the Mute Button Adjust the Volume Knob to Your Preferred Setting Display will NOW Time OUT and Return to Normal Operational Modes Balance mode Balance control tip Using Surround Sound Processors SSP must not be in a tape loop Ground Isolation Adaptor Linked Functions Care and Maintenance Canadian Warranty Obtaining Service Inputs SpecificationsDimensions Madrigal Audio Laboratories