FujiFilm 100, 90 owner manual Trouble Shooting, During operation Problems Possible Causes Solutions

Page 59

TROUBLE SHOOTING

During operation

Problems

 

 

 

Possible Causes

Solutions

 

Page

The shutter release won’t

1

“

” symbol is blinking.

1 Replace the battery with a new one.

17

trip.

 

2 Power switch is not on.

 

2 Press the POWER button.

 

16

 

 

3 Is “

” blinking on the LCD?

3 The flash is charging. Wait until “ ” stops blinking

30

 

 

 

 

 

 

and is displayed. (The flash takes approximately 6

 

 

 

 

 

 

 

seconds to charge.)

 

23

 

4

“ ” is lit on the exposure counter.

4 Remove the film, and load an unexposed roll.

 

 

 

 

5 Is the AF lamp blinking in the mode?

5 Photograph at 0.5 - 1.0 m (1.6-3.3 ft.) or use the

56

 

 

 

 

 

 

AF lock so that the AF lamp is lit.

 

The numerals on the ex-

 

●

Did you remove film without rewinding

● Remove the battery momentarily, then reload it.

35

posure counter blink.

 

 

it after you began photographing?

 

 

 

After loading the film it re-

 

 

 

 

 

 

 

 

wound immediately.

 

 

 

 

 

 

 

 

 

 

 

 

 

After loading the film and

 

1 Did you pull the end of the film out to

1 Pull the end of the film out to the FILM TIP mark

23

closing the camera back,

 

 

the FILM TIP mark when loading the

and correctly load the film.

 

 

the exposure counter does

 

 

film?

 

 

 

 

 

not advance.

 

2 Did you insert the battery after loading

2 A picture can not be taken by pressing the shutter

17,24

 

 

 

the film?

 

release button in that condition. Open the camera

 

 

 

 

 

 

 

back a little and close it again.

 

 

The film rewound during

 

●

Did you operate the

button in the

● Be sure not to move the

button while film is

37

photographing.

 

 

middle of the film?

 

loaded in the camera.

 

 

59

Page 58 Page 60
Image 59
Page 58 Page 60
Contents Page Features ContentsPart Names →p.37 Page Quick Start Guide Compose the picture Press the shutter button down completely Selecting the mode Flash →p.39 SELF-TIMER →p.46,49Focus → p.53 Finder AF Lamp AF lamp status and meaning Attaching the Strap Preliminary StepsYour camera uses one 3V lithium battery, type CR2/DL CR2 Loading the BatteryTurning on Your Camera Checking Your Battery Setting the Date YEAR-MONTH-DAY/HOUR-MINUTE You can set Press any Buttons to make the Date menu blink Date modes Selecting the Date ModePress Buttons and select the Date mode Loading the Camera Using Your CameraPage Insert the roll of film Close the camera back Using Your Camera Page Page Press down the shutter release halfway Page Page Using the AUTO-FOCUS Lock Check that the AF lamp green lights up Unloading the Film or Removing Film in MID-ROLL Remove the film When rewinding is complete, the exposure counter will read Page Flash modes Selecting the Flash ModePress the buttons and select the Flash mode ISO 19.0 ft 13.1 ft 26.6 ft 18.4 ft 11.6 m 38.1 ft 26.2 ft Red-eye reduction flash mode Multi program flash modeDealing with red-eye When using red-eye reduction modeFlash-off mode Back light compensation flash modeNight portrait slow sync mode SELF-TIMER modes Selecting the SELF-TIMER ModePress Buttons to make the SELF-TIMER menu blink/light Compose the picture and press the shutter release button Selecting the Remote Controller Mode Press Buttons and select Mode Page M 11 ft 16 ft Focus modes Selecting the Focus ModePress any Buttons to make the Focus menu blink Landscape mode AF Auto focus modeMacro mode Close-up photography in a room or night scene Multi Program FlashPhotography against the sun Portrait photography under very bright lightDuring operation Problems Possible Causes Solutions Trouble ShootingPrinted pictures Problems Possible Causes Solutions Common Sense Camera Care ∙ Viewfinder Specifications∙ Power Supply Important Safety Notice Page FGS-103106-Ci-01
Top Page Image Contents