JVC TM-15L1D manual Safety Precautions

Page 4

Safety Precautions (cont.)

Make enough room for inserting or removing the power plug. Place the product as close to the outlet as possible. The main power supply for the product is controlled by inserting or removing the power plug.

When the product is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the cables.

Do not overload wall outlets, extension cords, or convenience receptacles on other equipment as this can result in a risk of fire or electric shock.

Use only the accessory cord designed for this product to prevent shock.

Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltages and other hazards. Refer all service to qualified service personnel.

Do not put heavy objects on the product.

Do not rest your arm on the product or lean against the product.

Do not hang on the product when installing the product on the wall.

Power-supply cords should be routed so that they are not likely to be walked on or pinched by

items placed upon or against them. Pay particular attention to cords at doors, plugs, receptacles, and the point where they exit from the product.

When the product is used on a table with casters, lock the casters to prevent the product from falling over.

• Do not use the monitor for a long time if the sound is distorted.

Do not use this product near water.

Do not use immediately after moving from a low temperature to high temperature, as this causes condensation, which may result in a fire, electric shock, or other hazards.

Be sure to install the product in the place where proper temperature and humidity are kept (“Environmental conditions” on page 21).

This product becomes hot during its use. Take enough care when handling the product.

4

Image 4
Contents TM-15L1D Safety Precautions FCC Notice U.S.A. onlyPower Connection How to replace the fuseSafety Precautions English Maintenance ScreenCabinet Ventilation openingsContents Controls and Features Front panelPower lamp Aspect button/lampBlue CHECK/COLOR OFF button/lamp Input Select buttons/lampsRear panel AC inletVideo terminals Remote external control terminal MakeSDI terminals Security slotSDI 1 terminal BNC SDI 2 terminal BNCInstallation Using the monitor on the standTo adjust the stand height To detach the standInstalling the monitor on the wall Installing the monitor on the rackHow to Use the Main Menu Setting value 00Setting value AUTO, NTSC, PAL Main Menu itemsHow to Use the SET-UP Menu SET-UP Menu items Delay Time Setting value GREEN, REDSetting value ON, OFF No Sync DisplayHow to Use the External Control How to use the MAKE/TRIGGER terminalAbout the external control Functions to be controlled Opening Short-circuitingTroubleshooting Power onFollowing are not malfunctions Picture sizeSpecifications VideoFront View Side View Rear View without the stand