JVC GR-DLS1 manual Return, Sound signals can be sampled at 32 kHz or 48 kHz

EN37

SCENE	5S
BEEP / TALLY	ON
WIND CUT	OFF
SOUND MODE	32kHz
ID NUMBER	06

4RETURN

5S5SDANIM.

ONOFF

ONOFF

32kHz48kHz

This number is necessary when connecting the camcorder to a computer [01 to 99].

SCENE (5-Second Mode) (☞ pg. 28) WIND CUT

5S–Pressing START/STOP allows you to take a 5- second “clip”. Press repeatedly for a succession of short recordings.

5SD–If you record a 5-second clip within 5 minutes after the previous one, the end of the old scene dissolves and is replaced by the new scene over a 2-second period.

ANIM. (Animation)–Each time you press START/ STOP, a 1/8-second recording is taken. By using an inanimate object and changing its position between shots, you can record the subject as though it’s moving.

•Animation is not available in the LP mode. If you tried to record in the LP mode after setting ANIM., the recording mode indicator "LP" begins to blink, and recording goes on in the SP mode.

NOTE:

During use of SCENE effect, focus (☞ pg. 47) and exposure control (☞ pg. 48) enter Full Auto operation.

When activated, this mode helps cut down on noise created by wind.

ON–When shooting in high winds, noise is automatically reduced.

•“” appears.

•The quality of the sound will change. This is normal. OFF–This function is disabled.

NOTE:

The Wind Cut mode is disabled during Full Auto operation.

SOUND MODE

Sound signals can be sampled at 32 kHz or 48 kHz.

32 kHz–The camcorder is factory-preset for 32 kHz. This setting enables recording of stereo sound on four separate channels, and is recommended for use when performing Audio Dubbing.

48 kHz–This setting enables recording of stereo sound on two separate channels.

BEEP/TALLY

The beep sounds when the power is turned on or off, and at the beginning and end of recording. Tally lamp lights up during recording.

The following two Pro Snapshot modes (☞ pg. 30) have a shutter sound effect: Pro Snapshot mode with no frame, Pro Snapshot mode with frame. ON–To activate the beep/shutter sounds and tally lamp.

OFF–To turn off the beep/shutter sounds and tally lamp. Even though not heard while shooting, shutter sound is recorded on the tape.

NOTE:

A tape recorded at 48 kHz cannot be used for Audio Dubbing.