JVC GR-DVL28, GR-DVL33, GR-DVL48, GR-DVL38 specifications 56 EN

Page 56

56EN

CAUTIONS(cont.)

Cassettes

To properly use and store your cassettes, be sure to read the following cautions:

1. During use . . .

.... make sure the cassette bears the Mini DV

mark.

.... be aware that recording onto prerecorded

tapes automatically erases the previously recorded video and audio signals.

.... make sure the cassette is positioned properly

when inserting.

.... do not load and unload the cassette

repeatedly without allowing the tape to run at all. This slackens the tape and can result in damage.

.... do not open the front tape cover. This exposes

the tape to fingerprints and dust.

2. Store cassettes . . .

.... away from heaters or other heat sources.

.... out of direct sunlight.

.... where they won’t be subject to unnecessary

shock or vibration.

.... where they won’t be exposed to strong

magnetic fields (such as those generated by motors, transformers or magnets).

.... vertically, in their original cases.

LCD Monitor

1.To prevent damage to the LCD monitor, DO NOT . . .

.... push it strongly or apply any shocks.

.... place the camcorder with the LCD monitor on the bottom.

2.To prolong service life . . .

.... avoid rubbing it with coarse cloth.

3.Be aware of the following phenomena for LCD monitor use.

These are not malfunctions:

•While using the camcorder, the surface around the LCD monitor and/or the back of the LCD monitor may heat up.

•If you leave power on for a long time, the surface around the LCD monitor becomes hot.

Main Unit

1. For safety, DO NOT . . .

.... open the camcorder’s chassis.

.... disassemble or modify the unit.

.... short-circuit the terminals of the battery pack.

Keep it away from metallic objects when not in use.

.... allow inflammables, water or metallic objects

to enter the unit.

.... remove the battery pack or disconnect the

power supply while the power is on.

.... leave the battery pack attached when the

camcorder is not in use.

2. Avoid using the unit . . .

.... in places subject to excessive humidity or dust.

.... in places subject to soot or steam such as near

a cooking stove.

.... in places subject to excessive shock or

vibration.

.... near a television set.

.... near appliances generating strong magnetic or

electric fields (speakers, broadcasting anten- nas, etc.).

.... in places subject to extremely high (over 40°C)

or extremely low (under 0°C) temperatures.

3.DO NOT leave the unit . . .

.... in places of over 50°C.

.... in places where humidity is extremely low (below 35%) or extremely high (above 80%).

.... in direct sunlight.

.... in a closed car in summer.

.... near a heater.

4.To protect the unit, DO NOT . . .

.... allow it to become wet.

.... drop the unit or strike it against hard objects.

.... subject it to shock or excessive vibration

during transportation.

.... keep the lens directed at extremely bright

objects for long periods.

.... expose the lens to direct sunlight.

.... carry it by holding the LCD monitor or the

viewfinder.

.... swing it excessively when using the shoulder

strap or the grip.

Image 56
Contents GR-DVL48 GR-DVL38 GR-DVL33 GR-DVL28 Dear Customer It is recommended that youEN3 Safety Precautions How to Attach The Core Filter EN5Power Charging the Battery PackSlide the battery in the opposite direction of the arrow Lithium-ion is vulnerable in colder temperaturesUsing the Battery Pack Using AC PowerTo Detach The Battery Pack EN7Date/Time Settings EN Getting StartedLoading/Unloading a Cassette EN9Recording Mode Setting EN Getting StartedGrip Adjustment Viewfinder AdjustmentShoulder Strap Attachment Tripod MountingTo Adjust The Brightness Of The Display 12 ENBasic Recording Shooting While Watching ViewfinderPower Switch Position EN13Journalistic Shooting SELF-RECORDINGSlide the Power Zoom Lever towards T Slide the Power Zoom Lever towards W14 EN ZoomFeature Video Light GR-DVL48/ DVL38 only To brighten the scene when natural lighting is too dimEN15 Set Light OFF/AUTO/ON as requiredWhen a blank portion is recorded on a tape 16 ENProper recording ShootingRecording Advanced Features SnapshotSnapshot Recording If you press during Record-StandbyAdvanced Features Using Menus For Detailed AdjustmentMode Menu Explanations Recording Menu ExplanationsSystem Menu Explanations Factory presetDate/Time Menu Explanations LCD Monitor/Viewfinder Indications Before the following steps, perform steps 1 through 4 above22 EN Fade/Wipe EffectsPicture Wipe or Dissolve Selection If you select Picture Wipe/Dissolve during recordingMenu EN23Fader And Wipe Menu 24 EN Programme AE With Special EffectsShutter Variable Shutter Speed Slow Slow ShutterFocusing EN25Auto Focus Manual FocusTo Return To Automatic Exposure Control 26 ENExposure Control Iris Lock EN27Before the following steps, perform steps 1 through 4 pg To Return To Automatic Iris ControlWhite Balance Adjustment Manual White Balance OperationTo Return To Automatic White Balance To Change The Tint For RecordingLoad a tape pg Set the Power Switch to To Control The Speaker VolumeAvailable only with the RM-V711U remote control provided pg Basic PlaybackPlayback Menu Playback Menu allows you to set the following functionsPlayback Sound Display Displaying the Date During PlaybackEN31 Time Code Displaying The Time Code During Playback32 EN Basic ConnectionsIf using a VCR . . . go to step If not . . . go to step EN33When connecting cables, open this cover 34 ENPlayback Advanced Connections Connection To a Personal ComputerMake sure all units are turned off Connection To a Video Unit Equipped With a DV ConnectorEN35 36 EN Tape DubbingVCR Recording deck Engage the VCR’s AUX and Record-Pause modesDigital Dubbing EN37Installing The Battery 38ENEN39 Functions ButtonsFeature Playback Zoom Feature Slow-Motion PlaybackFeature Frame-By-Frame Playback To allow you to add creative effects to the playback image Feature Playback Special EffectsEN41 Create edited videos easily using your camcorder as 42 ENSET REMOTE/VCR Code You are now ready to try Random Assemble EditingUse the plug which has three yellow rings around the pin EN43Make Connections 44 EN Select ScenesNot start editing EN45Automatic Editing to VCR 46 EN For More Accurate EditingDiagnosing VCR/CAMCORDER Timing Recording deckAdjustment of VCR/CAMCORDER Timing EN4748 EN Audio DubbingTape END appears Position except EN49Corrective Action 50 EN Mode is set to OFF Even when Slow Shutter isIndicators disappear Date/Time Menu Scene transition does not52 EN Can resume using Brightness setting is tooHave become dirty ex Can cause damage Fingerprints Check the sectionTurn off the camcorder Cleaning The CamcorderAfter Use To prevent damage and prolong service life EN55To avoid hazard Do not burn56 EN Serious malfunctioning EN57About moisture condensation 58EN E 0 Q 9 WEN59 Displays the operation mode position 60 ENIndications 444Function LCD Monitor/Viewfinder Indications During PlaybackEN61 62 EN EN63 AC Power Adapter/Charger AA-V20ED or AA-V20SHCamcorder GR-DVL28