JVC GR-DVL25, GR-DVL45 Date/Time Menu Explanations, System Menu Explanations, Factory preset

20ENRECORDING

AdvancedFeatures(cont.)

Date/Time Menu Explanations

INDICATION	ON	Makes all the indications appear in the camcorder (☞ pg. 21).
	OFF	Keeps all the indications (except the tape running indicator, warnings,
		etc.) from appearing in the camcorder (☞ pg. 21).
ON SCREEN*	OFF	Keeps the camcorder’s display from appearing on the connected TV
		screen.
	ON	Makes the camcorder’s display appear on screen when the camcorder is
		connected to a TV.
DISPLAY	ON	Makes the date/time settings appear in the camcorder (☞ pg. 21).
	OFF	Keeps the date/time settings from appearing in the camcorder.
DATE/TIME	Allows you to set the current date and time (☞ pg. 8).

*You can also change “ON SCREEN” to “ON” or “OFF” by pressing the DISPLAY button on the RM-V711U remote control.

System Menu Explanations

TELE MACRO	OFF	Usually the distance to a subject where the lens is in focus depends on
		the zoom magnification. Unless there is a distance more than 1m to the
		subject, the lens is out of focus at the maximum telephoto setting. When
	ON	set to “ON”, you can shoot a subject as large as possible at a distance of
		approx. 60 cm.
		•Depending on the zoom position, the lens may go out of focus.
WIND CUT	OFF	Disengages the function which cuts down on noise created by wind.
	ON	Helps cut down on noise created by wind.
		•“ ” appears.
		•The quality of the sound will change. This is normal.
SOUND MODE	32 kHz	Enables recording of stereo sound on four separate channels, and is
		recommended for use when performing audio dubbing.
	48 kHz	Enables recording of stereo sound on two separate channels.
ID NUMBER	This number is necessary when connecting the camcorder to a device such as a
	computer using the J terminal (JLIP). The numbers range from 01 to 99. Factory setting
	is 06.
DEMO. MODE	OFF	Automatic demonstration will not take place.
	ON	Demonstrates certain functions such as Programme AE with special
		effects, etc., and can be used to confirm how these functions operate.
		When “DEMO. MODE” is set to “ON” and the Recording Menu is
		closed, demonstration starts.

NOTES:

●If a tape is in the camcorder, the demonstration cannot be turned on.

●By turning off the camcorder, “DEMO. MODE” is set to “OFF” automatically.

: Factory preset