Line in L+R SEPARATE-COMBINED, Auxiliary, Output

LINE IN L+R (SEPARATE-COMBINED)

Combines the separate left and right AUX LINE IN channels. This combined signal will be amplified and appear on both the LEFT and RIGHT channels of the SPEAKER and LINE OUT OUTPUTS.

AUXILIARY

To add pre-recorded music or sound effects during your presentation, just plug your CD player, tape player or computer sound card into the LINE IN jack. Separate VOLUME and TONE control knobs let you balance the program source with the live microphones. If using an external wireless receiver, for best sound quality it should be connected to the LINE IN jack.

OUTPUT

To tape record your speech or program, connect the LINE OUT on the amplifier (using cable with standard 3.5mm plug) to the input on a tape recorder.

SPEAKERS

Two separately amplified speaker jacks allow you to use one or two speakers for additional sound power or true stereo output. Note: when using a stereo AUX source with a single speaker, only one of the stereo channels will be heard. However, all MIC inputs are heard equally on both channels.

ANTENNA

Jack for wireless antenna. (Antenna supplied on ‘C’ Channel for mounting on either side of amplifier or use Velcro for optional mounting locations.)

INTERNAL WIRELESS RECEIVER(on right side of case)

Power on and off and Frequency A-B switches. Frequency should match wireless transmitter.

PROBLEM SOLVING

HOWLBACK is the howl or screech often heard in sound reinforcement systems. It is caused by sound from the loudspeaker returning to the microphone. AmpliVox systems utilize proven acoustical principles to minimize this; however, there is no way to completely eliminate howlback under conditions of high amplification. If howlback occurs check the following:

1.User’s hand covering the head of the microphone. [Hold microphone under head slots.]

2.Sound can easily re-enter microphone. Keep loudspeaker turned toward audience. Note: sound can be reflected from a hard surface back through the microphone. [Turn speaker.]

3.User holding microphone in a reflecting position. [Turn microphone.]

4.Volume setting too high. [Reduce microphone channel volume; compensate by speaking louder or closer to the microphone.]

NO SOUND

Make sure amplifier POWER switch is turned on and red LED is lit. If switch is on and LED is not lit, check to see that batteries are properly connected and at full charge. If using optional power adapter, check to see that front panel connector is properly seated, and verify that the power source is live.

IF YOU HAVE ANY QUESTIONS OR PROBLEMS PLEASE CALL OUR CUSTOMER SERVICE DEPARTMENT AT 1-800-267-5486