JVC GR-DVM1DU manual About moisture condensation, Serious malfunctioning

Page 79

2. Store cassettes . . .

79

5. Dirty heads can cause the folowing problems:

..... away from heaters or other heat sources.

 

..... out of direct sunlight.

 

..... where they won’t be subject to unnecessary

 

shock or vibration.

 

..... where they won’t be exposed to strong magnetic

 

fields (such as those generated by motors,

 

transformers or magnets).

 

..... vertically, in their original cases.

 

Main Unit

1. For safety, DO NOT . . .

..... open the camcorder’s chassis.

..... disassemble or modify the unit.

..... short-circuit the terminals of the battery pack.

Keep it away from metallic objects when not in use.

..... allow inflammables, water or metallic objects to

enter the unit.

..... remove the battery pack or disconnect the

power supply while the power is on.

..... leave the battery pack attached when the

camcorder is not in use.

2. Avoid using the unit . . .

..... in places subject to excessive humidity or dust.

..... in places subject to soot or steam such as near a

cooking stove.

..... in places subject to excessive shock or vibration.

..... near a television set.

..... near appliances generating strong magnetic or

electric fields (speakers, broadcasting antennas, etc.).

..... in places subject to extremely high (over 40°C

or 104°F) or extremely low (under 0°C or 32°F) temperatures.

3. DO NOT leave the unit . . .

..... in places of over 50°C (122°F).

..... in places where humidity is extremely low

(below 35%) or extremely high (above 80%).

..... in direct sunlight.

..... in a closed car in summer.

..... near a heater.

4.To protect the unit, DO NOT . . .

..... allow it to become wet.

..... drop the unit or strike it against hard objects.

..... subject it to shock or excessive vibration during transportation.

..... keep the lens directed at extremely bright objects for long periods.

..... expose the lens to direct sunlight.

..... carry it by holding the LCD monitor.

..... swing it excessively when using the hand strap.

..... swing the soft camera case excessively when the camcorder is inside it.

No picture during playback.

Blocks of noise appear during playback.

During recording, the Head Clog Warning indicator “” appears in the LCD moitor.

In such cases, use the optional Cleaning Cassette. Insert it and play back. If the cassette is used more than once consecutively, damage to the video heads may result. After the camcorder plays back for about 20 seconds, it stops automatically. Also refer to the Cleaning Cassette’s instructions.

If, after using the Cleaning Cassette, the problems still exist, consult your nearest JVC dealer.

LCD monitor

1.To prevent damage to the LCD monitor, DO NOT . . .

..... push it strongly or apply any shocks.

..... place the camcorder with the LCD monitor on the bottom.

2.To prolong service life . . .

..... avoid rubbing it with coarse cloth.

3.Make be aware of the following phenomena for LCD monitor use. These are not mulfunctions. . . .

•While using the camcorder, the surface around the LCD monitor and/or the back of the LCD monitor may heat up.

•If you leave power on for a long time, the surface around the LCD monitor becomes hot.

About moisture condensation . . .

You have observed that pouring a cold liquid into a glass will cause drops of water to form on the glass‘ outer surface. This same phenomenon occurs on the head drum of a camcorder when it is moved from a cool place to a warm place, after heating a cold room, under extremely humid conditions or in a place directly subjected to the cool air from an air conditioner.

Moisture on the head drum can cause severe damage to the video tape, and can lead to internal damage to the camcorder itself.

Serious malfunctioning

If malfunctioning occurs, stop using the unit immediately and consult your local JVC dealer.

Image 79
Contents GR-DVM1D It is recommended that you Dear CustomerGrounding or Polarization Power SourcesPower Cord Protection Power LinesSafety Check AccessoriesDamage Requiring Service Replacement PartsSafety Precautions Sun hood Cleaning clothSoft camera case CAM Stand GripContents Detach Charging The Battery PackDetach BATTERY/BATTERIES AttachClose Battery Cover Installing The Battery PackOpen Battery Cover Insert BatteryAttach to CAM Stand Using The CAM StandSupply Power Indoor UseReplace Battery Holder Clock Lithium Battery CR2025 Insertion/RemovalRemove OLD Battery Insert NEW BatteryOpen LCD Monitor Date/Time SettingsSelect Operation Mode Access Recording MenuTo protect valuable recordings Loading/Unloading a CassetteOpen Cassette Door INSERT/REMOVE TapeHand Strap Attachment Recording Mode SettingLens Cover Detachment Detach SUN Hood Sun Hood AttachmentAttach SUN Hood Open SUN HoodGrip Attachment Grip AdjustmentInstalling The Battery Remote Control UnitRE-INSERT Holder Full Auto/Manual Operation END Recording Turn on PowerBasic Recording Start RecordingStart Search Select ModeEngage Still Mode Recording From The Middle Of a TapePartway through the tape When blank portion is recorded on a tapeTime Code During shootingGrasp Camcorder Holding The CamcorderLCD Monitor Indications Adjust BrightnessTilt LCD Monitor Interface Shooting Zoom Take Snapshot Motor Drive modeChanging the Snapshot Setting SnapshotTo Stop a Snapshot Search In Progress Snapshot SearchRewind Tape Begin SearchTo Take a Snapshot In The 5-Second Mode Press the PUSH-OPENswitch and open the LCD monitor fullyScene To Take a Snapshot In The Self-Timer Mode Self-Timer, press Snapshot instead Press MENU. The Recording Menu appears in the LCD monitor MenusSelect Function Close Recording MenuZoom Magnification DIS Digital Image StabilizerSystem Menu Access System MenuClose System Menu END SET Menu Button Sound signals can be sampled at 32 kHz or 48 kHzSelect Effect FADE/WIPE EffectsFades and Wipes Press Recording START/STOP Picture Wipe/DissolveResume Recording Dissolve? R Random Fader Random VariationsClose Menu Accessmenu FADER/WIPE CustomizeExchanging FADE/WIPE Effects Select NEW EffectFades and Wipes Refer to page 34 on using the exchanged effectsAE/Effects Disable P.AE/EFFECTStrobe Monotone √Video Echo Sepia √ Classic Film √Exchanging P.AE/Effects Accessmenu P.AE/EFFECT CustomizeDisplaying The Date And Time During Recording Select Auto in . Or set the shooting Mode selector to Auto White Balance AdjustmentTo Return To Automatic White Balance To Change The Tint For Recording Enter SettingManual White Balance Operation Exit Recording MenuAdjust Focus Manual Focus AdjustmentTo Change To Auto Focus To Return To Automatic Exposure Control Adjust ExposureExposure Control Brightness control of the LCD monitorIris Lock REC Ording Advanced FeaturesYou can watch what you’ve recorded in the LCD monitor Viewing RecordingEND Playback To Perform High-Speed SearchStart Playback Select TV’S Video ModeVCR/TV Connection Connectvcr Camcorder to TV orAttach and Locks Confirm POWER-OFF StatusUsing The Remote Control During Playback Docking Station AttachmentRecording deck TV PlaybackConnect as shown in the illustration pg Turn on Power Select TV’S Video ModeConnect Docking Station to TV or VCR Connectinput VCR Output to TV Start PlaybackPress Menu again, and the menu disappears Access Playback MenuPlayback Menu To set parameters for other functions, repeat steps 3Displaying the Date During Playback Playback SoundDisplaying The Time Code During Playback END Zoom Playback ZoomActivate Zoom Locatescene Portion of MagnifiedPress Play Playback EffectsPause Recording Docking StationDubbing Make ConnectionsRelease SET Button Brand SettingPress and Hold MBR SET Button Enter BrandExecute FADE/WIPE To Operate The VCR With The Remote ControlRandom Assemble Editing Start Source PlaybackUSE P.AE/EFFECT SET EDIT-IN PointSET EDIT-OUT Point USE Fade Wipe on Scene TRANSI- TionStart Editing Engagemode Vcrs RECORD-PAUSEStop Editing RM-V708U For More Accurate EditingPrepare for R.A. Edit Play Back Dubbed Scene Choose a ScenePress MENU. The Playback Menu appears on the TV screen Input Correction DataNow perform Random Assemble Editing beginning with on Pause During Dubbing Audio DubbingFind EDIT-IN Point Begin DubbingPrepare for Insert Editing Stop Editing Insert EditingFind Edit OUT Point Start Recording Find Edit in Point Pause During EditingPlay pg 5-Second mode Select 5S or 5SDREC pg Close the cassettes coverEffect pg TR Ouble ShootingPicture Wipe function doesn’t work Squeeze or Cinema mode is selected in the Recording MenuPossible Causes This may occur when Cleaning The Camcorder Main Unit Name & Function LCD Monitor Indications During RecordingLCD Monitor Indications During Playback Jlip Video Capture Docking Station Video Area Audio Area Sub-Code AreaITI Insert and Tracking Information Area Plug adapter Using Household AC Plug AdapterSerious malfunctioning About moisture condensationVideo signal recording format PowerPower consumption Format Signal formatConnectors Video Battery LifePower consumption Output powerNtsc Play Back on TV Pgs , 52, 54, 56 Motor Drive ModeConnections Pg , 50, 51 On-Screen Menus ............................ pgsGR-DVM1D