JVC DZ-VCA3U manual Camera control unit rear panel, Ntsc Output Ntsc output section

Camera control unit (rear panel)

1

~AC IN

NTSC OUT	GENLOCK	SXGA OUT		HD OUT
	IN/OUT
DV			GBR	Y
			(1)
				PB
Y/C
(S)
			GBR
			(2)
				PR
VBS

2

3 4

1[AC INPUT] power input connector To input AC120V.

2Equal-potential connector

3Cover for extension slot

Remove the cover to install an optional device in this slot.

4[NTSC OUTPUT] NTSC output section

Output of DV signals, Y/C(S) signals, VBS (compos- ite video signals).

The power supply for IEEE1394 interface is not available from DV connector.

5 6 7

5[GENLOCK IN/OUT] sync signal input/output Input/output of composite sync signal for external sync. (menu-based switching).

6[SXGA OUT] SXGA output section Output of progressive scan GBR signal.

SXGA output signal cannot be displayed on the DT- V1900CGU.Use the monitor that is compliant with the following scanning frequency.

Horizontal: 67.4325kHz, vertical: 59.94Hz

7[HD OUT] video signal output section

Output of HD (Y, PB, PR) video signals (interlace scan).

When HD video signals are connected to Hi-vision monitor, the screen will have a width/length ratio of 16:9, and the picture will extend sideways.

Camera head

2

1Lens mount ring

Standard C mount is used.

Flange back will be 17.526mm in air.

2Camera cable connector (plug) Connect to camera control unit.

11