Sync menu | JVC DZ-VCA3U instruction

Names of parts and their functions (continued)

LMENU-PAGE 2

. P A G E

G A M M A

E N H A N C E

A L C

L MENU-PAGE 3

. P A G E	3
D . S H A D I N G
N R
M . B L A C K
S Y N C

H O U R M E T E R 0 0 0 3 H 5 4 M

[GAMMA] menu

Select a gamma correction or no gamma correction.

Selected item	Gamma
0.43	=0.43
0.45	=0.45
0.47	=0.47
0.49	=0.49
OFF	No gamma correction =1.0

[ENHANCE] menu

Select the contour compensation value or no-contour com- pensation.

The leftmost on the minus side is the setting for no-contour compensation, and the other 6 levels are for contour compen- sation.

[ALC] menu

[ZONE] sub-menu

Change the size of the zone where automatic sensitiv- ity control and auto white level detection is performed. Select [FULL], [LARGE], [MEDIUM], or [SMALL] with [LEFT]/[RIGHT] button.

[DET] sub-menu

Select the level detection method for automatic sensitivity control from peak detection (P), average detection (A), or the combination of both. Use the [LEFT]/[RIGHT] button to select from 5 different levels. The far left is only for peak detection, while the far right is for average detection only. In between there are 3 levels for both peak and average detections.

[D.SHADING] menu

For correction of dynamic shading. (colour appearing on the screen in vertical direction.)

No correction at the centre. ± 7 levels of correction is possible.

[GREEN] sub-menu

Increase the green gain at the top of the screen by setting the + side. (Reducing the green gain at the bottom of the screen.)

Reduce the green gain at the top of the screen by setting the - side. (Increasing the green gain at the bottom of the screen.)

[RED] sub-menu

Increase the red gain at the top of the screen by setting the + side. (Reducing the red gain at the bottom of the screen.)

Reduce the red gain at the top of the screen by setting the - side. (Increasing the red gain at the bottom of the screen.)

[NR] menu

To set frame-turning type noise reduction.

HIGH : Large noise reduction effect. (In frequent moving ob- jects, the shadow may be obvious)

LOW : Suppressed noise reduction setting.

OFF : Noise reduction is OFF.

[M.BLACK] menu

Select the master black (setup) value. From the centre with no setup, change of ±3 steps each side at about 7% step is possible.

[SYNC] menu

Switching between sending GENLOCK basic signal, or input basic signal from other device.

[HOUR METER] display

Indicates accumulated time of power usage.

It cannot be selected with cursor.