Setting the Lens Switches | JVC TK-C215V4U manual

Introduction

Setting the Lens and

Switches

Set the video setting switches on the camera unit before mounting it.

To set the switches, use a fine-tipped screwdriver.

ARESET/[SPOT]

A [RESET/SPOT] RESET/SPOT button

When this button is pressed, the value of the white balance or phase adjusted manually is reset to the default value.

● When the 2 [SELECT] switch is set to

WHT.BAL., the white balance is reset to the

default value.

When the switch is set to PHASE, the phase

is reset to the default value.

● When setting to SPOT:

When this button is pressed, white spots are

corrected.

For instructions on correcting white spots, see

LLPHASE

1 O

2 N 2

AWhite-spot correctionB (A pg. 21).

B [R/B, +/-] R/B, +/- adjustment button

This button is pressed when manually

adjusting the white balance or when adjusting

the vertical phase of the line lock.

C	4	4
	3
	5		WHT.
	5
	6
	7		BAL.
	8

L H

IRIS

ELEVEL

FOCUS ADJUST

Function selection switch setting table (Items in bold are factory position)

		OFF	ON

1	AGC	OFF	ON
2	SELECT	PHASE	WHT.BAL.
3	SYNC	LL	INT
4	WHT.BAL.	ATW	MANU
5	BLC	OFF	ON
6	DAY/NIGHT	OFF	ON
7	RESERVED	SET TO OFF
8	RESET/SPOT	RESET	SPOT

The function of this button is selected using

the 2 [SELECT] switch.

● When manually adjusting the white balance:

Press the R button to increase the red tint and

decrease the blue tint.

Press the B button to increase the blue tint

and decrease the red tint.

● When adjusting the phase:

Press the + or - button to adjust the phase.

C Function selection switches

1.[AGC] Auto-gain control switch.

Setting this switch to AONB automatically increases the sensitivity even when the brightness of the subject is insufficient. (Default setting: ON)

2.[SELECT] WHT.BAL./PHASE setting switch.

WHT.BAL.:

The B [R/B, +/-] buttons are used as [R/B] adjustment buttons.

PHASE:

The B [R/B, +/-] buttons are used as [+/-] adjustment buttons.

(Default setting: WHT.BAL.)

3.[SYNC] Synchronization system selection switch.

This switch sets the synchronizing system for the camera.

INT:

This is set for internal synchronization

LL (Line Lock):

The camera’s vertical synchronization is locked to the AC 24 V 60 Hz power line frequency. When switching between multiple cameras using a switcher, selecting this mode and adjusting the vertical phase can reduce the monitor sync disturbances occur that when the camera image is switched.

(Default setting: INT)