Installation and connection
4. Remove the inner dome
Mounting the Camera (continued)
Embedding the camera to the ceiling
The inner dome is secured with claws (3 locations). Hold the inner dome and remove it from the claws.
5.Remove the outer case.
(This method does not require an outer case.)
*Make use of a ceiling material with a thickness between 9.5 mm to 22 mm.
Setup
1.Open a hole in the ceiling. (R120 mm, 4 3/4 inches)
2.Draw the fall prevention wire mounted to the ceiling slab and the cable out from the ceiling in advance.
CAUTION:
●Select a suitable fall prevention wire based on length, strength, location, material (insulation property), etc.
●Use a ring on the fall prevention wire for mounting to the camera unit with an internal diameter of at least R3.1 mm or and not larger than R5.5 mm, and an external diameter that is not larger than R 9 mm.
A Loosen the camera fastening screw with a screwdriver
B To remove, turn the camera unit in the counterclockwise direction
6.Dismantle the supplied fall prevention wire
Unfasten the mounting screw for the fall prevention wire at the rear of the camera unit
7.Loosen the pan fastening screw.
CAUTION:
Moving the lens unit without loosening the pan fastening screw may damage the lens unit.
8.Set the switches for video images. ( A pg. 10)
1.
R120 mm
(4 3/4 inches)
Inner Dome
Fall prevention | Approx. 100 mm |
wire | (3 7/8 inches) |
(not supplied) |
|
2.
4.
5. Pan fastening
7. | A Screw |
|
Video signal cable | Power supply cable |
| |
3. Remove the dome cover. |
| ||
As illustrated in the diagram, hold the dome | Claws | ||
ring such that the position mark comes | |||
(3 locations) | |||
between the thumb and index finger. Turn the | |||
| |||
ring in the counterclockwise direction to |
| ||
remove. |
| Camera | |
|
| Fastening Screw | |
3.
5. B | 6. |
| |
| Washer |
Dome Ring
Position mark
14