JVC GR-AX650U, GR-AX610U manual Zoom indicator Zoom-in, Retake, Power zoom switch, START/STOP Viss

RECORDING Basic Features

Zoom indicator

Zoom-in

T	T	T	T
W	W	W	W
		Zoom-out

RETAKE

Power zoom switch

START/STOP

VISS

RM-V700U (optional)

15

FEATURE:	Zooming
PURPOSE:	Varies the focal length of the lens and
	produces the zoom in/out effect.
OPERATION:	Zoom In
	1) Pull the power zoom switch down
	toward “T”.
	Zoom Out

2)Push the switch up toward “W”.

NOTES: ● The further the power zoom switch is

	pushed, the faster the zoom speed
	becomes.
	● Focusing may become unstable during
	zooming. In this case, set the zoom while
	in Record–Standby, set manual focus or
	Focus Lock (☞ pg. 20, 21), then zoom in
	or out in Record mode.
FEATURE:	Quick Review
PURPOSE:	To check the end of the last recording.
OPERATION:	1) Press “ ” for less than 2 seconds during
	the Record–Standby mode.
	• Tape is rewound for about 2 seconds
	and played back automatically, then
	pauses in Record–Standby mode for the
	next shot.
NOTE:	Distortion may occur at start of playback.
	This is normal.
FEATURE:	Retake
PURPOSE:	To re-record certain segments.
OPERATION:	1) Make sure the camcorder is in the
	Record–Standby mode.
	2) Press either RETAKE button to reach the
	start point for new recording.
	3) Press Recording Start/Stop to start
	recording.
NOTE:	Noise may appear during Retake.
	This is normal.
FEATURE:	Index Code Marking
PURPOSE:	To give you automatic access to any selected
	point on a recording. Auto Marking and
	Manual Marking are available.
OPERATION:	Auto Marking
	An index code is always marked to start the
	first recording on a new date after a cassette
	is inserted.
	Manual Marking (Using the optional
	RM-V700U Remote Control Unit)
	1) Press VISS once to place the index code.
	INDEX blinks in the viewfinder during
	marking.
NOTES:	● If VISS is pressed during
	Record–Standby mode, the mark is
	placed where START/STOP is pressed.
	● If the date changes during a recording, it
	becomes the first recording of the new
	date and an index mark is placed at that
	point.