JVC GR-D90 GR-D70 instruction manual Wipe/Fader, Program AE, Exposure, Balance, Camera

Page 28

For Recording Menu

This camcorder is equipped with an easy-to-use, on-screen menu system that simplifies many of the more detailed camcorder settings ( pg. 28 – 31).

1 Set the Power Switch u to “ ” while pressing down the Lock Button y located on the switch. Open the LCD monitor fully or pull out the viewfinder fully.

2 Press the MENU/VOLUME wheel % in. The Menu Screen appears.

3 Rotate the MENU/VOLUME wheel % to select the desired function menu, and press it.

4 Function menu setting depends on the function.

If you have selected “ WIPE/FADER”,

“ PROGRAM AE”, “ EXPOSURE” or

“ W. BALANCE” . . .

..... see the column on the right.

If you have selected “ CAMERA”, “ MANUAL”,

“ SYSTEM”, “ CAMERA DISPLAY” or

“ DSC” . . .

..... go to step 5.

5 Rotate the MENU/VOLUME wheel % to select the desired function and press it. The Sub Menu appears. Then, rotate the MENU/VOLUME wheel % to select the parameter, and press it. Selection is complete.

6 Rotate the MENU/VOLUME wheel % to select

“ RETURN” and press it twice. The Menu Screen closes.

• The icon represents “END”.

NOTE:

When the Menu Screen is left on for a couple of minutes, a residual image may be left on the screen and it may take several seconds for the residual image to disappear. This is not due to any defect of the unit.

WIPE/FADER

Refer to “Fade/Wipe Effects” ( pg. 24).

PROGRAM AE

Refer to “Programme AE With Special Effects” ( pg. 23).

EXPOSURE

Refer to “Exposure Control” and “Iris Lock” ( pg. 26, 27).

W.BALANCE

Refer to “White Balance Adjustment” and “Manual White Balance Operation” ( pg. 27).

CAMERA

Settings made in the “ CAMERA” Menu remain effective whether the Power Switch u is set to “ ” or

“ ”. However, the menu settings can be changed only when the Power Switch u is set to “ ”.

CAMERA

REC MODE

–

 

SOUND MODE

–

12b i t

ZOOM

–

40X

SNAP

MODE

–

FULL

GA I N

UP

–

AGC

RETURN

REC MODE

Allows you to set the tape recording mode ([SP] or LP) depending on your preference ( pg. 10).

SOUND MODE

[12bit]: Enables tape recording of stereo sound on four separate channels, and is recommended for use when performing audio dubbing. (Equivalent to the 32 kHz mode of previous models)

16bit: Enables tape recording of stereo sound on two separate channels. (Equivalent to the 48 kHz mode of previous models)

ZOOM

16X: When set to “16X” while using digital zoom, the zoom magnification will reset to 16X since digital zoom will be disengaged.

[40X]: Allows you to use the Digital Zoom. By digitally processing and magnifying images, zooming is possible from 16X (the optical zoom limit), to a maximum of 40X digital magnification.

700X: Allows you to use the Digital Zoom. By digitally processing and magnifying images, zooming is possible from 16X (the optical zoom limit), to a maximum of 700X digital magnification.

[ ] = Factory-preset

EN

28 USING MENUS FOR DETAILED ADJUSTMENT

Page 27 Page 29
Image 28
Page 27 Page 29
Contents GR-D90 GR-D70 Contents Safety Precautions Before recording an important scene Make sure the arrow is Pointing upward Wind once StopperSub Menu Power Charging the Battery PackUsing the Battery Pack Using AC PowerGrip Adjustment Viewfinder AdjustmentLithium-ion is vulnerable in colder temperatures About BatteriesApproximate recording time Tape Recording mode Shoulder Strap AttachmentTripod Mounting Loading/Unloading a CassetteRecording Mode Setting Date/Time SettingsScreen closes Loading a Memory Card Picture Quality/Image Size Setting To Unload a Memory CardLabel Clipped edge Memory card DisplayBasic Recording To Adjust The Brightness Of The DisplayTape Recording Operation Mode Power-Linked OperationJournalistic Shooting Self-RecordingTo Control The Speaker Volume Time CodeRecording from the Middle of a Tape Normal PlaybackTo cancel Blank Search midway Blank SearchPress Blank Search Tape PlaybackIf using a VCR . . . go to step If not . . . go to step ConnectionsBasic Shooting Snapshot To Delete Unwanted Still ImagesTo Remove The Shutter Sound To Protect Valuable Files available only for SD Memory CardMultiMediaCard Approximate Number of Storable ImagesTo Magnify The Stored Images Viewing File Information Auto PlaybackIndex Playback Removing On-Screen DisplayProtecting Files Deleting Files Advanced FeaturesTo Remove Protection Setting Print Information Dpof Setting To Reset The SettingDubbing Still Images Recorded On a Tape To a Memory Card To Print ALL Still Images ONE Print for EachTo Reset The No. Of Prints Initialising a Memory CardMaking a New Folder Folder and File namesNight-Scope Programme AE With Special EffectsFade/Wipe Effects Snapshot Mode Selection Snapshot For Tape RecordingSnapshot Recording Auto FocusManual Focus Exposure ControlTo Return To Automatic Exposure Control To Brighten The Subject QuicklyIris Lock White Balance AdjustmentManual White Balance Operation WIPE/FADER Program AEExposure BalanceManual System Camera DisplayFor Playback Menu DSCVideo Video Display Playback SoundDisplay Bright , DATE/TIME , Time CodeDubbing To Or From a VCR To Use This Camcorder As a PlayerTo Use This Camcorder As a Recorder DubbingTo DV @ Core filter DV cable Optional Core filter To DVUsing the Remote Control Unit Slow-Motion PlaybackFrame-By-Frame Playback Playback Special EffectsSet 12bit Mode to Sound 2 or MIX Menu Screen  pg Audio DubbingInsert Editing To hear the dubbed sound during playbackSET REMOTE/VCR Code Random Assemble Editing R.A.EditMake Connections Select Scenes Adjustment of VCR/CAMCORDER Timing Automatic Editing to VCRFor More Accurate Editing Diagnosing VCR/CAMCORDER TimingUsing USB cable Using DV cableUsing USB cable Connection To a Personal ComputerNo power is supplied Focus does not adjust automaticallySnapshot mode cannot be used Image taken using Snapshot is too darkBlack & White Fader does not work Image looks like the shutter speed is too SlowWhite Balance cannot be activated Date/time does not appearCharger indicator on the camcorder does Not light An error indication E01, E02 or E06 appearsAn error indication E03 or E04 appears Memory card cannot be played backCassettes Battery PacksMemory Cards LCD Monitor How to handle a CD-ROMMain Unit For Your Maintenance Cleaning The CamcorderAfter Use About moisture condensationCamcorder AC AdapterControls, Connectors And Indicators Remote ControlIndex LCD monitor@ Digital Video Input/Output Connector Power Switch pg Audio/Video Input/OutputLCD Monitor/Viewfinder Indications 2b i t / SOUND1During Memory Card Recording Only 1024 During Both Tape And Memory Card RecordingAppears when in the Squeeze or Cinema mode Appears when the Insert Editing w or Insert EditingDisplays the sound mode for approx seconds after Appears when Digital Image Stabiliser DIS isHigh E03 or E04 Unit in Safeguard Mode Eject E01, E02 or E06 Unit in Safeguard ModeAppears if a file in another format is selected Using The Optional RM-V717U Remote Control Unit RM-V717U optionalTerms See previous page as well
Top Page Image Contents