JVC GR-D90 GR-D70 instruction manual Grip Adjustment, About Batteries, Viewfinder Adjustment

Page 8

Since the AC Adapter processes electricity internally, it becomes warm during use. Be sure to use it only in well-ventilated areas.

The following operation stops charging:

Set the Power Switch u to “PLAY”, “ ” or “ ”.

Disconnect the AC Adapter from the camcorder.

Unplug the AC Adapter from the AC outlet.

Detach the battery from the camcorder.

This camcorder will be automatically turned off if its power is supplied from the AC adapter and about 5 minutes pass since it has entered into the recording standby mode with a cassette inserted. If, under those conditions, the battery is attached to the camcorder, its charging will start.

Using the optional AA-V40 AC Power Adapter/Charger, you can charge the BN-V408U/V416U/V428U battery pack without the camcorder. However, it cannot be used as an AC adapter.

To avoid interference with reception, do not use the AC Adapter near a radio.

Perform charging where the temperature is between 10°C and 35°C. 20°C to 25°C is the ideal temperature range for charging. If the environment is too cold, charging may be incomplete.

Charging time varies according to the ambient temperature and the status of the battery pack.

Grip Adjustment

1 Separate the Velcro strip.

2 Pass your right hand through the loop and grasp the grip.

3 Adjust your thumb and fingers through the grip, to easily operate the Recording Start/Stop button e and Power Switch u and Power Zoom Lever &. Be sure to fasten the Velcro strip to your preference.

&

u e

About Batteries

DANGER! Do not attempt to take the batteries apart, or expose them to flame or excessive heat, as it may cause a fire or explosion.

WARNING! Do not allow the battery or its terminals to come in contact with metals, as this can result in a short circuit and possibly start a fire.

The Benefits Of Lithium-Ion Batteries

Lithium-ion battery packs are small but have a large power capacity. However, when one is exposed to cold temperatures (below 10°C), its usage time becomes shorter and it may cease to function. If this happens, place the battery pack in your pocket or other warm, protected place for a short time, then re-attach it to the camcorder. As long as the battery pack itself is not cold, it should not affect performance.

(If you’re using a heating pad, make sure the battery pack does not come in direct contact with it.)

Viewfinder Adjustment

1 Set the Power Switch u to “ ” or “ ” while pressing down the Lock Button y located on the switch.

2 Pull out the viewfinder fully and adjust it manually for best viewability.

3 Turn the Dioptre Adjustment Control w until the indications in the viewfinder are clearly focused.

PAUSE

Lithium-ion is vulnerable in colder temperatures.

EN

w

y u

8 GETTING STARTED

Image 8
Contents GR-D90 GR-D70 Contents Safety Precautions Before recording an important scene Make sure the arrow is Pointing upward Sub Menu StopperWind once Power Charging the Battery PackUsing the Battery Pack Using AC PowerGrip Adjustment Viewfinder AdjustmentLithium-ion is vulnerable in colder temperatures About BatteriesApproximate recording time Tape Recording mode Shoulder Strap AttachmentTripod Mounting Loading/Unloading a CassetteScreen closes Date/Time SettingsRecording Mode Setting Loading a Memory Card Picture Quality/Image Size Setting To Unload a Memory CardLabel Clipped edge Memory card DisplayTape Recording To Adjust The Brightness Of The DisplayBasic Recording Operation Mode Power-Linked OperationJournalistic Shooting Self-RecordingTo Control The Speaker Volume Time CodeRecording from the Middle of a Tape Normal PlaybackTo cancel Blank Search midway Blank SearchPress Blank Search Tape PlaybackIf using a VCR . . . go to step If not . . . go to step ConnectionsBasic Shooting Snapshot To Delete Unwanted Still ImagesTo Remove The Shutter Sound To Protect Valuable Files available only for SD Memory CardTo Magnify The Stored Images Approximate Number of Storable ImagesMultiMediaCard Viewing File Information Auto PlaybackIndex Playback Removing On-Screen DisplayTo Remove Protection Advanced FeaturesProtecting Files Deleting Files Setting Print Information Dpof Setting To Reset The SettingDubbing Still Images Recorded On a Tape To a Memory Card To Print ALL Still Images ONE Print for EachTo Reset The No. Of Prints Initialising a Memory CardMaking a New Folder Folder and File namesNight-Scope Programme AE With Special EffectsFade/Wipe Effects Snapshot Mode Selection Snapshot For Tape RecordingSnapshot Recording Auto FocusManual Focus Exposure ControlTo Return To Automatic Exposure Control To Brighten The Subject QuicklyManual White Balance Operation White Balance AdjustmentIris Lock WIPE/FADER Program AEExposure BalanceManual System Camera DisplayVideo DSCFor Playback Menu Video Display Playback SoundDisplay Bright , DATE/TIME , Time CodeDubbing To Or From a VCR To Use This Camcorder As a PlayerTo Use This Camcorder As a Recorder DubbingTo DV @ Core filter DV cable Optional Core filter To DVUsing the Remote Control Unit Slow-Motion PlaybackFrame-By-Frame Playback Playback Special EffectsSet 12bit Mode to Sound 2 or MIX Menu Screen  pg Audio DubbingInsert Editing To hear the dubbed sound during playbackMake Connections Random Assemble Editing R.A.EditSET REMOTE/VCR Code Select Scenes Adjustment of VCR/CAMCORDER Timing Automatic Editing to VCRFor More Accurate Editing Diagnosing VCR/CAMCORDER TimingUsing USB cable Using DV cableUsing USB cable Connection To a Personal ComputerNo power is supplied Focus does not adjust automaticallySnapshot mode cannot be used Image taken using Snapshot is too darkBlack & White Fader does not work Image looks like the shutter speed is too SlowWhite Balance cannot be activated Date/time does not appearCharger indicator on the camcorder does Not light An error indication E01, E02 or E06 appearsAn error indication E03 or E04 appears Memory card cannot be played backMemory Cards Battery PacksCassettes Main Unit How to handle a CD-ROMLCD Monitor For Your Maintenance Cleaning The CamcorderAfter Use About moisture condensationCamcorder AC AdapterControls, Connectors And Indicators Remote ControlIndex LCD monitor@ Digital Video Input/Output Connector Power Switch pg Audio/Video Input/OutputLCD Monitor/Viewfinder Indications 2b i t / SOUND1During Memory Card Recording Only 1024 During Both Tape And Memory Card RecordingAppears when in the Squeeze or Cinema mode Appears when the Insert Editing w or Insert EditingDisplays the sound mode for approx seconds after Appears when Digital Image Stabiliser DIS isHigh Appears if a file in another format is selected E01, E02 or E06 Unit in Safeguard ModeE03 or E04 Unit in Safeguard Mode Eject Using The Optional RM-V717U Remote Control Unit RM-V717U optionalTerms See previous page as well