JVC GR-D240 manual Basic Recording, Tape Remaining Time, Approximate recording time

	VIDEO RECORDING EN 17
Basic Recording	Tape Remaining Time
	Approximate tape remaining
NOTE:
	time appears on the display.
Before continuing, perform the procedures listed	“– h – – m” means the
below:	camcorder is calculating the
● Power ( pg. 11)	remaining time. When the
● Loading A Cassette ( pg. 16)	remaining time reaches 2 minutes, the indication
Power Zoom Lever	starts blinking.
	● The time required to calculate and display the
Power Switch	remaining tape length, and the accuracy of the
	calculation, may vary according to the type of tape
Lock Button	used.
POWER/CHARGE Lamp
Recording Start/Stop Button

1 Remove the lens cap. (
pg. 10)

2 Open the LCD monitor fully.

3 Set the Power Switch to “A” or “M” while pressing down the Lock Button located on the switch.

●The POWER/CHARGE lamp lights and the camcorder enters the Record-Standby mode. “PAUSE” is displayed.

●To record in LP (Long Play) mode,
pg. 23.

4 To start recording, press the Recording Start/ Stop Button. “T REC” appears on the display while recording is in progress.

5 To stop recording, press the Recording Start/ Stop Button again. The camcorder re-enters the Record-Standby mode.

Approximate recording time

Tape	Recording mode
	SP	LP
30 min.	30 min.	45 min.
60 min.	60 min.	90 min.
80 min.	80 min.	120 min.

NOTES:

●If the Record-Standby mode continues for

5 minutes, the camcorder’s power shuts off automatically. To turn the camcorder on again, push back and pull out the viewfinder again or close and re-open the LCD monitor.

●When a blank portion is left between recorded scenes on the tape, the time code is interrupted and errors may occur when editing the tape. To avoid this, refer to “Recording From The Middle Of A Tape” (
pg. 19).

●To turn the beep sounds off,
pg. 22, 25.

VIDEO RECORDING & PLAYBACK