JVC GR-D240 Power, Charging The Battery Pack, Slide the strap guide fully towards the eyelet

Connect the AC Adapter to the camcorder.

		GETTING STARTED	EN 11
How To Attach The Shoulder Strap
		Power
Follow the illustration.
	This camcorder’s 2-way power supply system
1 Thread the strap through the eyelet.
	lets you choose the most appropriate source of
2 Fold it back and thread it through the strap	power. Do not use provided power supply units
guide and the buckle.	with other equipment.
● To adjust the length of the strap, loosen and then	Charging The Battery Pack
tighten the strap in the buckle.

3 Slide the strap guide fully towards the eyelet.

Buckle

Strap guide

2 2

M A OFF PLAY

POWER/

CHARGE

Power switch POWER/CHARGE lamp Battery pack mount

PUSH BATT.

Battery pack

GETTING STARTED

		Arrow
		mark
1	3	To DC connector
		Open the cover.
Eyelet

To AC outlet

AC Adapter (ex. AP-V17E)

1 Set the Power Switch to “OFF”.

2 With the arrow on the battery pack pointing downward, push the battery pack slightly against the battery pack mount a.

3 Slide down the battery pack until it locks in place b.

4

5 Connect the Power Cord to the AC Adapter. (AP-V14E only)

6 Plug the AC Adapter into an AC outlet. The POWER/CHARGE lamp on the camcorder blinks to indicate charging has started.

7 When the POWER/CHARGE lamp goes out, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.

CONTINUED ON NEXT PAGE