EN19
NOTE: Recording From The Middle Of A Tape
Time Code
During recording, a time code is recorded on the tape. This code is to confirm the location of the recorded scene on the tape during playback.
If recording starts from a blank portion, the time code begins counting from “00:00:00” (minute:second:frame). If recording starts from the end of a previously recorded scene, the time code continues from the last time code number.
To perform Random Assemble Editing ( pg. 45 – 50), time code is necessary. If during recording a blank portion is left partway through the tape, the time code is interrupted. When recording is resumed, the time code starts counting up again from “00:00:00”. This means the camcorder may record the same time codes as those existing in a previously recorded scene. To prevent this, perform “Recording From The Middle of A Tape” below in the following cases;
•When shooting again after playing back a recorded tape.
•When power shuts off during shooting.
•When a tape is removed and
•When shooting using a partially recorded tape.
•When shooting on a blank portion located partway through the tape.
•When shooting again after shooting a scene then opening/closing the cassette holder cover.
Display
|
|
|
|
|
|
| Frames are not displayed | ||
|
|
|
|
|
|
| during recording. | ||
|
|
|
|
|
|
|
|
| Minutes |
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
| Seconds |
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| Frames |
TC 1 |
| 2 : 3 |
| 4 : 2 |
| 4 |
|
| (30 frames = 1 second) |
|
|
|
|
| |||||
Recording From The Middle Of A Tape
1.Play back a tape to find the spot at which you want to start recording, then engage the Still Playback mode ( pg. 31).
2.Set the Power Switch to “
” or “ 
” while pressing down the Lock Button located on the switch, then start recording.
NOTES:
●The time code cannot be reset.
●During
●The time code is displayed only when “TIME CODE” is set to “ON” ( pg. 25, 32).
When a blank portion is recorded on a tape
Time code | Time code | Time code |
00:00:00 | 05:43:21 | 00:00:00 |
Tape
Already recorded scene
Blank
Newly recorded scene
Shooting start pointShooting stop point Shooting start point
Proper recording
Time code | Time code | Time code |
00:00:00 | 05:43:21 | 05:44:00 |
Tape
Already recorded scene
New scene
Latest scene
Shooting start point | Shooting start point | Shooting start point |