JVC GR-DVL166 12 EN, Loading/Unloading a Cassette, Approximate recording time Tape Recording mode

Page 12

12 EN

GETTING STARTED (cont.)

Erase protection tab*

Make sure the window side is facing out.

Cassette holder

OPEN/EJECT

Switch

Cassette holder cover

PUSH HERE

* To Protect Valuable Recordings . . .

.... slide the erase protection tab on the back of the

tape in the direction of “SAVE”. This prevents the tape from being recorded over. To record on this tape, slide the tab back to “REC” before loading it.

Be sure to press only the section labeled “PUSH HERE” to close the cassette holder; touching other parts may cause your finger to get caught in the cassette holder, resulting in injury or product damage.

Loading/Unloading A Cassette

The camcorder needs to be powered up to load or eject a cassette.

1 Slide and hold OPEN/EJECT in the direction of the arrow then pull the cassette holder cover open until it locks. The cassette holder opens automatically.

• Do not touch internal components.

2 Insert or remove a tape and press “PUSH HERE” to close the cassette holder.

•Once the cassette holder is closed, it recedes automatically. Wait until it recedes completely before closing the cassette holder cover.

•When the battery’s charge is low, you may not be able to close the cassette holder cover. Do not apply force. Replace the battery with a fully charged one before continuing.

3 Close the cassette holder cover firmly until it locks into place.

Approximate recording time

Tape

Recording mode

 

 

SP

LP

 

 

 

 

30 min.

30 min.

45 min.

 

 

 

60 min.

60 min.

90 min.

 

 

 

80 min.

80 min.

120 min.

 

 

 

NOTES:

●It takes a few seconds for the cassette holder to open. Do not apply force.

●If you wait a few seconds and the cassette holder does not open, close the cassette holder cover and try again. If the cassette holder still does not open, turn the camcorder off then on again.

●If the tape does not load properly, open the cassette holder cover fully and remove the cassette. A few minutes later, insert it again.

●When the camcorder is suddenly moved from a cold place to a warm environment, wait a short time before opening the cassette holder cover.

●Closing the cassette holder cover before the cassette holder comes out may cause damage to the camcorder.

●Even when the camcorder is switched off, a cassette can be loaded or unloaded. After the cassette holder is closed with the camcorder switched off, however, it may not recede. It is recommended to turn the power on before loading or unloading.

●When resuming recording, once you open the cassette holder cover a blank portion will be recorded on the tape or a previously recorded scene will be erased (recorded over) regardless of whether the cassette holder came out or not. See page 18 for information about recording from the middle of a tape.

●Loosen the Grip Strap if it appears to interfere with the cassette holder cover operation ( pg. 10).

Page 11 Page 13
Image 12
Page 11 Page 13
Contents GR-DVL166 Dear Customer It is recommended that youBlue to N Neutral or Black Brown to L Live or Red Some DO’S and DON’TS on the Safe USE of Equipment Above ALLBefore recording an important scene How To Attach The Lens Cap How To Attach The Core Filter While pressing downGetting Started Power Charging the Battery PackBattery pack Charging time To Detach The Battery PackUsing the Battery Pack Using AC PowerAbout Batteries Approximate recording timeGrip Adjustment Viewfinder Adjustment10 EN Shoulder Strap AttachmentDate/Time Settings Set the Power Switch toMENU/BRIGHT Wheel Power Lamp Lock Button DisplayApproximate recording time Tape Recording mode 12 ENLoading/Unloading a Cassette Recording Mode Setting Set the tape recording mode depending on your preferenceMenu Screen 14 EN Remove the lens cap Set the Power Switch to To Adjust The Brightness Of The DisplayBasic Recording To Stop RecordingOperation Mode Power Switch Position16 EN Journalistic ShootingSlide the Power Zoom Lever towards T To brighten the scene when natural lighting is too dimZoom Zoom OutWhen a blank portion is recorded on a tape 18 ENTime Code Proper recordingTo Control The Speaker Volume Normal PlaybackSpeaker 20 EN ConnectionsCamcorder If using a VCR . . . go to step If not . . . go to step Turn on the camcorder, the VCR and the TVTo cancel Blank Search midway 22 ENBlank Search PressAdvanced Features To Deactivate The Selected Mode 24 ENNight-Scope To Deactivate Night-ScopeShutter SnowSpotlight TwilightPower Switch Recording Start/Stop Button 26 ENFade/Wipe Effects To Deactivate The Selected EffectFader And Wipe Menu Snapshot Mode Selection 28 ENSnapshot Snapshot RecordingWhile focusing on a nearer subject To obtain correct focusFocus detection zone Subject30 EN Exposure ControlIris Lock White Balance Adjustment Manual White Balance OperationCloud Halogen32 EN For Recording MenuWIPE/FADER Program AEMenu Screen Explanations Manual System Tele OFF MacroWide OFF CinemaCAM Cancel Reset ExecuteSystem Display Demo OFF LCDFollowing procedure applies to all except Synchro Comp  pg 36 ENFor Playback Menu Lock Button Recording Start/Stop ButtonSound Mode Playback SoundDisplay 38 EN Dubbing To a VCRVCR Cvbs Video outTo DV Lock Button Core filterDV cable Core filter To DV40 EN Lock holeKnob Remote sensor This function is unavailable with this camcorder 42 EN Remote sensor RM-V700U optional Zoom ButtonsNormal playback Press T SET REMOTE/VCR Code VCR Recording deckThis one Connect the editing cable to the Remote Pause connector Connect the editing cable to the R.A.EDIT Connector44 EN Make ConnectionsSelect Scenes Remote sensor RM-V700U optional46 EN Automatic Editing to VCREditing Menu Adjustment of VCR/CAMCORDER Timing For More Accurate EditingDiagnosing VCR/CAMCORDER Timing ProgrammeSet 12BIT Mode to Sound 2 or MIX Menu Screen  pg 48 ENAudio Dubbing To hear the dubbed sound during playbackInsert Editing Using PC connection cable Using DV cable50 EN References 52 EN Cold, charging may be incompleteSepia or Monotone mode is  pg Activated Used  pg Colour of SnapshotFind a white subject and compose 54 EN Or set the Power Switch to OFF IndicatorsTurn the speaker volume down Rear of the LCD monitor56 EN Cleaning The Camcorder After UseRemove Cassette holder BATT. Release Button58 EN For safety, do not Avoid using the unitDirty heads can cause the following problems Do not leave the unit60 EN Power requirement Video OutputAudio output JlipIndex Controls, Connectors And Indicators 62 ENOPEN/EJECT Switch  pg Power SwitchVideo Light Switch  pg DC Input Connector  pg Digital Video ConnectorAppears when the Power Switch is set to  pg Appears when Night-Scope is engaged64 EN Index IndicationsVolume Displays the sound modeLCD Monitor/Viewfinder Indications During Playback 66 EN Backlight Compensation Channels Left/RightDarken The LCD Monitor Erase ProtectionPg , 35 Unload a TapeVideo Light White Balance

GR-DVL166 specifications

The JVC GR-DVL166 is a compact digital video camcorder that was designed for both amateurs and budding filmmakers seeking to capture high-quality footage without the complexities of more advanced systems. Released in the early 2000s, this model has a range of impressive features and characteristics that set it apart in its class.

One of the standout features of the GR-DVL166 is its ability to record in a 16:9 aspect ratio, which was a key innovation at the time. This widescreen feature allows users to capture a cinematic feel in their home videos, making it particularly appealing for those who wanted to create more engaging visual content. The camcorder also boasts a 1/6-inch 680,000 pixel CCD image sensor, which delivers quality video that remains vibrant and clear, even in various lighting conditions.

Another noteworthy characteristic of the GR-DVL166 is its 20x optical zoom lens. This impressive zoom capability allows users to get up close to the action without sacrificing image quality. In addition to the optical zoom, the camcorder also supports a digital zoom feature, extending the range even further. However, it's the optical zoom that truly enhances the overall shooting experience, making it versatile for different filming scenarios.

The GR-DVL166 incorporates a built-in USB 2.0 interface, making it easier for users to transfer their footage to a computer for editing or sharing. This connectivity option was ahead of its time and simplified the post-production process. It also features a FireWire (IEEE 1394) connection, facilitating faster data transfer rates, particularly beneficial for larger video files.

The ergonomics of the JVC GR-DVL166 are also commendable. Its lightweight design, combined with an easy-to-navigate interface and a 2.5-inch LCD screen, ensures that users can easily handle the device and monitor their shots with precision. The LCD is flip-out, providing flexibility for shooting from different angles.

Battery life is another positive aspect, with the camcorder providing ample recording time on a single charge, which is ideal for capturing events that may require extended filming periods.

Overall, the JVC GR-DVL166 remains a notable choice for entry-level videographers. With its combination of a wide aspect ratio, optical zoom capabilities, user-friendly features, and solid build quality, it provides an appealing option for those looking to capture their memories in a more cinematic fashion. As digital photography and videography continue to evolve, models like the GR-DVL166 highlight the technological advancements of their time and their lasting impact on consumer video recording.
Top Page Image Contents