JVC GR-DVL910EA, GR-DVL210A, GR-DVL210EA, GR-DVL313A, GR-DVL910A, GR-DVL510A Insert Editing, EN67

Page 67
Press REW (2) until the Edit-In point is located, then press PAUSE (6).

Lock Button

Power Switch

Display

6w

12 : 34

Remote sensor

START/STOP

INSERT

PLAY

REW

STOP

 

PAUSE

EN67

Insert Editing

(GR-DVL910A/DVL510A/DVL910EA/DVL510EA only)

You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and outpoints. The original audio remains unchanged.

NOTES:

●Before performing the following steps, make sure that

“TIME CODE” is set to “ON” in the Menu Screen (  pg. 50).

●Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.

●To perform Insert Editing while watching in the television, make connections (  pg. 22).

1 Play back the tape, locate the Edit-Out point and press PAUSE (6). Confirm the time code at this point ( pg. 51).

2

3 Press and hold INSERT (w) on the remote control, then press PAUSE (6). “6w” and the Time Code (min.:sec.) appear and the camcorder enters Insert- Pause mode.

4 Press START/STOP to begin editing.

•Confirm the insert at the time code you checked in step 1.

•To pause editing, press START/STOP. Press it again to resume editing.

5 To end Insert Editing, press START/STOP, then STOP (5).

NOTES:

●Programme AE with special effects ( pg. 38, 39) can be used to spice up the scenes being edited during Insert Editing.

●During Insert Editing, the date and time information changes.

●If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.

●During Insert Editing, when the tape moves to scenes

recorded in the LP mode or a blank portion, Insert Edting stops (  pg. 84).

Page 66 Page 68
Image 67
Page 66 Page 68
Contents Instructions It is recommended that you Dear CustomerEN3 Make sure you only use cassettes with the Mini DV mark Before recording an important sceneGR-DVL910A/DVL510A Unit AC Adapter Remote Control UnitPower Cord AP-V10A RM-V717U BN-V408URelease the stoppers on both ends of the Core Filter How To Attach The Core FilterGetting Started ContentsSlide BAT. Release and pull out the battery pack PowerCharging the Battery Pack To Detach The Battery PackApproximate recording time Using the Battery PackUsing AC Power About BatteriesShoulder Strap Attachment Grip AdjustmentViewfinder Adjustment 10 ENEN11 Date/Time SettingsLoading/Unloading a Cassette 12 ENSet the tape recording mode depending on your preference Recording Mode SettingEN13 GR-DVL910A/DVL510A/DVL910EA/DVL510EA only Picture Quality Mode SettingLoading a Memory Card To Unload a Memory CardVideo Recording Playback Video Recording & PlaybackBasic Recording To Adjust The Brightness Of The Display16 EN Video RecordingSELF-RECORDING Operation ModeEN17 Journalistic ShootingZoom Out Slide the Power Zoom Lever towards T18 EN ZoomSet Light OFF/AUTO/ON as required Feature Video LightTo brighten the scene when natural lighting is too dim EN19Proper recording When a blank portion is recorded on a tape20 EN Time CodeEN21 To Control The Speaker VolumeVideo Playback Normal PlaybackVideo Playback 22 ENEN23 If using a VCR . . . go to step If not . . . go to stepPress Blank Search To cancel Blank Search midway24 EN Blank SearchDigital Still Camera C. Recording Playback Snapshot Recording Snapshot Mode Selection26 EN Basic Shooting SnapshotTo Delete Unwanted Still Images When unwanted still images are stored in the memoryWhen you do not want to hear the shutter sound, set EN27Automatically 28 ENAuto Playback You can run through all the images stored in memoryIndex Playback Index ScreenEN29 Jump Playback 30 ENTo Remove Protection Protecting ImagesEN31 To Protect AN ImageTo Select AN Image by Browsing 32 ENDeleting Images To Delete the Displayed ImageTo Delete ALL Images EN33Before doing the following, perform steps 1 through 3 on pg 34 EN To Reset The SettingTo Print ALL Still Images ONE Print for Each EN35 To Reset The No. Of PrintsTo Print by Selecting Still Images and NO. of Prints Initialising a Memory Card 36 ENYou can initialise a memory card anytime For Recording Advanced FeaturesProgramme AE With Special Effects 38 ENFor Recording Night-ScopeSlow Slow Shutter EN39Gives recorded scenes a strobe effect Your recording looks like a series of consecutive snapshotsPicture Wipe or Dissolve Selection 40 ENFade/Wipe Effects FADE/WIPE SelectionFader And Wipe Menu EN41Menu Effect Snapshot For Video Recording 42 ENTo obtain correct focus Feature Auto FocusFeature Manual Focus EN43Exposure Control 44 ENIris Lock To Return To Automatic White Balance White Balance AdjustmentManual White Balance Operation EN45See pg EN Using Menus for Detailed AdjustmentFor Recording Menu If you have selected WIPE/FADER Program AE or W. BalanceMenu Screen Explanations EN47Recording. Also to activate the shutter sound effect  pg Factory setting isActivates the shutter sound effect  pg EN49 For Playback Menu Following procedure applies to all except Synchro Comp  pgEN51 DisplayPlayback Sound To use this camcorder as a player 52 ENDubbing Dubbing To a VCREN53 Dubbing From a VCRVCR Playback deck Dubbing 54 ENEN55 Dubbing Images Stored In a Memory Card To a TapeDubbing Images Recorded On a Tape To a Memory Card 56 ENImages can be dubbed from a tape to a memory card Installing The Batteries Using the Remote Control UnitEN57 Unit 58 ENEN59 Feature Slow-Motion PlaybackFeature Frame-By-Frame Playback Feature Playback Special EffectsAny time during playback Feature Playback Zoom60 EN To magnify the recorded image up toSET REMOTE/VCR Code EN61VCR Recording deck VCR other than above JVC VCR equipped with a remote pause connectorMake Connections Also refer to pgEN63 Automatic Editing to VCR 64 ENDiagnosing VCR/CAMCORDER Timing Adjustment of VCR/CAMCORDER TimingFor More Accurate Editing EN65To hear the dubbed sound during playback Set 12BIT Mode to Sound 2 or MIX Menu Screen  pg66 EN Audio DubbingEN67 Insert EditingUsing DV cable Using USB or PC connection cableUsing DV cable AUsing USB or PC connection cableEN69 Connection To a Video Unit Equipped With a DV ConnectorReferences 70 EN pg When you use the LCD monitor outdoors in direct sunlight,Cassette holder cannot be opened unless a power supply is EN71Corrective Action 72 ENEN73 74 EN TroubleshootingEN75 76 EN Press Push Here to close the cassette holder User MaintenanceAfter Use Cleaning The Camcorder Turn off the camcorder5 6 78 ENEN79 Appears and blinks during shooting.  pg 80 ENStandard in order of quality EN81 Bright Displays the brightness of the LCD Displays the sound modeLevel indicator moves Displays the date LCD Monitor/Viewfinder Indications During Video PlaybackIndications Function EN83Protected SD Memory Card is loaded E01 E06 Switch is set toPossible Appears, the memory card is corruptedTo avoid hazards To prevent damage and prolong service lifeEN85  Do not use near flammable or explosive materials86 EN Serious malfunctioning EN87To protect the unit, do not About moisture condensationTerms 88 ENTime Code  pg , 49, 50 EN89For General 90 ENFor Digital Video Camera EN91 For ConnectorsS/EA 0201HOV*UN*SN

GR-DVL210EA, GR-DVL910EA, GR-DVL313A, GR-DVL510A, GR-DVL510EA specifications

The JVC GR-DVL210A, GR-DVL910A, GR-DVL450A, GR-DVL310A, and GR-DVL510EA represent a significant leap in the evolution of digital camcorders. These models are renowned for their user-friendly features, advanced technologies, and versatile characteristics, making them popular choices for both amateur videographers and seasoned professionals.

The JVC GR-DVL210A is a compact and lightweight digital camcorder that boasts a 1/6 inch CCD sensor, producing high-quality video recordings at 520 lines of resolution. Equipped with a 10x optical zoom and 800x digital zoom, this model allows users to capture detailed footage from a distance, while the image stabilization technology reduces blurriness caused by hand movement. Additionally, the GR-DVL210A features a 2.5-inch LCD screen that provides a clear view of the subject, enhancing the shooting experience.

Moving up the range, the GR-DVL910A offers enhanced features including a 1/4 inch CCD sensor, enabling improved light sensitivity for better performance in low-light conditions. This model is equipped with a 16:9 aspect ratio capability, making it suitable for capturing widescreen videos. The GR-DVL910A also includes advanced digital effects, allowing users to add creative touches to their recordings, along with a built-in digital still camera that captures high-resolution images.

The GR-DVL450A strikes a balance between performance and affordability. This model enhances image quality with a 1.5-inch LCD screen and improved 3D noise reduction technology. It comes with a powerful 20x optical zoom and 800x digital zoom, solidifying its place as a versatile option for capturing dynamic events.

The GR-DVL310A is notable for its ease of use, making it an ideal choice for beginners. Featuring automatic settings, this camcorder simplifies the filming process, allowing users to focus on creativity rather than getting bogged down by technicalities. Its digital effects and transition features make it perfect for those looking to enhance their video projects.

Finally, the GR-DVL510EA combines advanced features with an user-friendly interface. It includes a larger 3.5-inch LCD screen and multiple connectivity options, including USB 2.0 for easy file transfers. Capable of recording in various formats, the GR-DVL510EA appeals to a broad audience seeking a versatile camcorder.

In summary, the JVC GR-DVL series camcorders stand out for their technology and features, providing users with flexible filming options, clear video quality, and user-friendly designs, catering to a wide range of videography needs.
Top Page Image Contents