JVC GR-DVL510EA, GR-DVL210A, GR-DVL210EA, GR-DVL313A, GR-DVL910A How To Attach The Core Filter

Page 6

6 EN

How To Attach The Core Filter

Attach the Core Filter(s) (if provided with your model  pg. 5) to an optional cable(s). The Core Filter reduces interference.

1

Stopper

Release the stoppers on both ends of the Core Filter.

2

3 cm

 

 

 

 

Wind once

Run the cable through the Core Filter, leaving approx. 3 cm of cable between the cable plug and the Core Filter. Wind the cable once around the outside of the Core Filter as shown in the illustration.

•Wind the cable so that it is not slack.

NOTE:

Take care not to damage the cable.

3

Close the Core Filter until it clicks shut.

When connecting cables, attach the end with the Core Filter to the camcorder.

AUTOMATIC DEMONSTRATION

Automatic Demonstration takes place when “DEMO MODE” is set to “ON” (factory-preset).

 Available when the Power Switch is set to “ ” or “ ” and no cassette is in the camcorder.

Performing any operation during the demonstration stops the demonstration temporarily. If no operation is performed for more than 1 minute after that, the demonstration will resume.

“DEMO MODE” remains “ON” even if the camcorder power is turned off.

To cancel Automatic Demonstration:

1.Set the Power Switch to “ ” while pressing down the Lock Button located on the switch and press the MENU/BRIGHT wheel in. The Menu Screen appears.

2.Rotate the MENU/BRIGHT wheel to select “ SYSTEM” and press it. The SYSTEM Menu appears.

3.Rotate the MENU/BRIGHT wheel to select “DEMO MODE” and press it. The Sub Menu appears.

4.Rotate the MENU/BRIGHT wheel to select “OFF” and press it.

5.Rotate the MENU/BRIGHT wheel to select “1RETURN”, and press it twice. The normal screen appears.

NOTE:

If you do not detach the Lens Cap, you cannot see the actual changes of the Automatic Demonstration activated on the LCD monitor or viewfinder.

MENU/BRIGHT Wheel

Lock Button

Power Switch

Sub Menu

DEMO MODE – OFF

ON

GR-DVL910A/DVL510A/ DVL910EA/DVL510EA only

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Instructions Dear Customer It is recommended that youEN3 Before recording an important scene Make sure you only use cassettes with the Mini DV markAP-V10A RM-V717U BN-V408U AC Adapter Remote Control UnitPower Cord GR-DVL910A/DVL510A UnitHow To Attach The Core Filter Release the stoppers on both ends of the Core FilterContents Getting StartedTo Detach The Battery Pack PowerCharging the Battery Pack Slide BAT. Release and pull out the battery packAbout Batteries Using the Battery PackUsing AC Power Approximate recording time10 EN Grip AdjustmentViewfinder Adjustment Shoulder Strap AttachmentDate/Time Settings EN1112 EN Loading/Unloading a CassetteRecording Mode Setting Set the tape recording mode depending on your preferenceEN13 To Unload a Memory Card Picture Quality Mode SettingLoading a Memory Card GR-DVL910A/DVL510A/DVL910EA/DVL510EA onlyVideo Recording & Playback Video Recording PlaybackVideo Recording To Adjust The Brightness Of The Display16 EN Basic RecordingJournalistic Shooting Operation ModeEN17 SELF-RECORDINGZoom Slide the Power Zoom Lever towards T18 EN Zoom OutEN19 Feature Video LightTo brighten the scene when natural lighting is too dim Set Light OFF/AUTO/ON as requiredTime Code When a blank portion is recorded on a tape20 EN Proper recordingNormal Playback To Control The Speaker VolumeVideo Playback EN2122 EN Video PlaybackIf using a VCR . . . go to step If not . . . go to step EN23Blank Search To cancel Blank Search midway24 EN Press Blank SearchDigital Still Camera C. Recording Playback Basic Shooting Snapshot Snapshot Mode Selection26 EN Snapshot RecordingEN27 When unwanted still images are stored in the memoryWhen you do not want to hear the shutter sound, set To Delete Unwanted Still ImagesYou can run through all the images stored in memory 28 ENAuto Playback AutomaticallyIndex Screen Index PlaybackEN29 30 EN Jump PlaybackTo Protect AN Image Protecting ImagesEN31 To Remove ProtectionTo Delete the Displayed Image 32 ENDeleting Images To Select AN Image by BrowsingEN33 To Delete ALL ImagesBefore doing the following, perform steps 1 through 3 on pg To Reset The Setting 34 ENTo Print ALL Still Images ONE Print for Each To Reset The No. Of Prints EN35To Print by Selecting Still Images and NO. of Prints 36 EN Initialising a Memory CardYou can initialise a memory card anytime Advanced Features For RecordingNight-Scope 38 ENFor Recording Programme AE With Special EffectsYour recording looks like a series of consecutive snapshots EN39Gives recorded scenes a strobe effect Slow Slow ShutterFADE/WIPE Selection 40 ENFade/Wipe Effects Picture Wipe or Dissolve SelectionEN41 Fader And Wipe MenuMenu Effect 42 EN Snapshot For Video RecordingEN43 Feature Auto FocusFeature Manual Focus To obtain correct focus44 EN Exposure ControlIris Lock EN45 White Balance AdjustmentManual White Balance Operation To Return To Automatic White BalanceIf you have selected WIPE/FADER Program AE or W. Balance EN Using Menus for Detailed AdjustmentFor Recording Menu See pgEN47 Menu Screen ExplanationsFactory setting is Recording. Also to activate the shutter sound effect  pgActivates the shutter sound effect  pg EN49 Following procedure applies to all except Synchro Comp  pg For Playback MenuDisplay EN51Playback Sound Dubbing To a VCR 52 ENDubbing To use this camcorder as a playerDubbing From a VCR EN53VCR Playback deck 54 EN DubbingDubbing Images Stored In a Memory Card To a Tape EN5556 EN Dubbing Images Recorded On a Tape To a Memory CardImages can be dubbed from a tape to a memory card Using the Remote Control Unit Installing The BatteriesEN57 58 EN UnitFeature Playback Special Effects Feature Slow-Motion PlaybackFeature Frame-By-Frame Playback EN59To magnify the recorded image up to Feature Playback Zoom60 EN Any time during playbackEN61 SET REMOTE/VCR CodeVCR Recording deck Also refer to pg JVC VCR equipped with a remote pause connectorMake Connections VCR other than aboveEN63 64 EN Automatic Editing to VCREN65 Adjustment of VCR/CAMCORDER TimingFor More Accurate Editing Diagnosing VCR/CAMCORDER TimingAudio Dubbing Set 12BIT Mode to Sound 2 or MIX Menu Screen  pg66 EN To hear the dubbed sound during playbackInsert Editing EN67AUsing USB or PC connection cable Using USB or PC connection cableUsing DV cable Using DV cableConnection To a Video Unit Equipped With a DV Connector EN6970 EN ReferencesEN71 When you use the LCD monitor outdoors in direct sunlight,Cassette holder cannot be opened unless a power supply is  pg72 EN Corrective ActionEN73 Troubleshooting 74 ENEN75 76 EN Turn off the camcorder User MaintenanceAfter Use Cleaning The Camcorder Press Push Here to close the cassette holder78 EN 5 6EN79 80 EN Appears and blinks during shooting.  pgStandard in order of quality EN81 LCD Monitor/Viewfinder Indications During Video Playback Displays the sound modeLevel indicator moves Displays the date Bright Displays the brightness of the LCDEN83 Indications FunctionAppears, the memory card is corrupted Switch is set toPossible Protected SD Memory Card is loaded E01 E06 Do not use near flammable or explosive materials To prevent damage and prolong service lifeEN85 To avoid hazards86 EN About moisture condensation EN87To protect the unit, do not Serious malfunctioning88 EN TermsEN89 Time Code  pg , 49, 5090 EN For GeneralFor Digital Video Camera For Connectors EN91S/EA 0201HOV*UN*SN

GR-DVL210EA, GR-DVL910EA, GR-DVL313A, GR-DVL510A, GR-DVL510EA specifications

The JVC GR-DVL210A, GR-DVL910A, GR-DVL450A, GR-DVL310A, and GR-DVL510EA represent a significant leap in the evolution of digital camcorders. These models are renowned for their user-friendly features, advanced technologies, and versatile characteristics, making them popular choices for both amateur videographers and seasoned professionals.

The JVC GR-DVL210A is a compact and lightweight digital camcorder that boasts a 1/6 inch CCD sensor, producing high-quality video recordings at 520 lines of resolution. Equipped with a 10x optical zoom and 800x digital zoom, this model allows users to capture detailed footage from a distance, while the image stabilization technology reduces blurriness caused by hand movement. Additionally, the GR-DVL210A features a 2.5-inch LCD screen that provides a clear view of the subject, enhancing the shooting experience.

Moving up the range, the GR-DVL910A offers enhanced features including a 1/4 inch CCD sensor, enabling improved light sensitivity for better performance in low-light conditions. This model is equipped with a 16:9 aspect ratio capability, making it suitable for capturing widescreen videos. The GR-DVL910A also includes advanced digital effects, allowing users to add creative touches to their recordings, along with a built-in digital still camera that captures high-resolution images.

The GR-DVL450A strikes a balance between performance and affordability. This model enhances image quality with a 1.5-inch LCD screen and improved 3D noise reduction technology. It comes with a powerful 20x optical zoom and 800x digital zoom, solidifying its place as a versatile option for capturing dynamic events.

The GR-DVL310A is notable for its ease of use, making it an ideal choice for beginners. Featuring automatic settings, this camcorder simplifies the filming process, allowing users to focus on creativity rather than getting bogged down by technicalities. Its digital effects and transition features make it perfect for those looking to enhance their video projects.

Finally, the GR-DVL510EA combines advanced features with an user-friendly interface. It includes a larger 3.5-inch LCD screen and multiple connectivity options, including USB 2.0 for easy file transfers. Capable of recording in various formats, the GR-DVL510EA appeals to a broad audience seeking a versatile camcorder.

In summary, the JVC GR-DVL series camcorders stand out for their technology and features, providing users with flexible filming options, clear video quality, and user-friendly designs, catering to a wide range of videography needs.
Top Page Image Contents