JVC GR-DVL520, GR-DVL720 38 EN, Fade/Wipe Effects, Switch to, To Deactivate The Selected Effect

38 EN FOR RECORDING (cont.)

IMPORTANT

Some Fade/Wipe Effects cannot be used with certain modes of Program AE with special effects (
pg. 36, 37). If an unusable Fade/Wipe Effect is selected, its indicator blinks or goes out.

Lock Button

MENU/BRIGHT Wheel

	Power Switch
Recording
Start/Stop		VIDEO/MEMORY Switch
Button		(GR-DVL720/DVL520 only;
		open the LCD monitor to
		access this switch)

Fade/Wipe Effects

These effects let you make pro-style scene transitions. Use them to spice up the transition from one scene to the next.

Fade or Wipe works when tape recording is started or when you stop recording.

1 Set the VIDEO/MEMORY Switch to “VIDEO” (GR-DVL720/DVL520 only), then set the Power

Switch to “	” while pressing down the Lock
MANUAL

Button located on the switch.

2 Press the MENU/BRIGHT wheel in. The Menu Screen appears.

3 Rotate the MENU/BRIGHT wheel to select “ WIPE/FADER”, then press it.

4 Rotate the MENU/BRIGHT wheel to select the desired function, then press it. Selection is complete. Press the MENU/BRIGHT wheel in again.

•The WIPE/FADER Menu disappears and the effect is reserved. The indicator representing the selected effect appears.

5 Press the Recording Start/Stop Button to activate the Fade-in/out or Wipe-in/out.

To Deactivate The Selected Effect . . .

..... select “OFF” in step 4.

NOTE:

You can extend the length of a Fade or Wipe by pressing and holding the Recording Start/Stop Button.