JVC GR-DVL920 To Print by Selecting Still Images NO. of Prints, To Reset The No. Of Prints

Perform steps 1 through 4 on pg. 34.

EN 35

Fast-Forward (3) Button

Rewind Button (2)

MENU/BRIGHT Wheel

SELECT Button

VIDEO/MEMORY Switch (Open the LCD monitor to access this switch.)

Display

DPOF Screen

DPOF

SHEETS

0 0

RETURN

DPOF

SHEETS

0 5

DPOF

SAVE?

EXECUTE

CANCEL

TO PRINT BY SELECTING STILL IMAGES AND

NO. OF PRINTS

1

2 Rotate the MENU/BRIGHT wheel to select

“CURRENT” and press it. Selection is complete. The DPOF Screen appears.

3 Press 2or 3 so that the image you wish to print appears.

4 Rotate the MENU/BRIGHT wheel to move the highlight bar to the SHEETS number indication and press it.

5 Select the number of prints by rotating the MENU/ BRIGHT wheel and press it.

Repeat steps 3 through 5 for the desired number of prints.

•The number of prints can be set up to 15.

•To correct the number of prints, select the image again and change the number.

6 Rotate the MENU/BRIGHT wheel to select “RETURN” and press it. Selection is complete. “SAVE?” appears.

•If you did not change any settings in step 3 through 5, the Menu Screen reappears.

7 Rotate the MENU/BRIGHT wheel to select

“EXECUTE”, then press it to save the setting you have just made.

•To cancel selection, rotate the MENU/BRIGHT wheel to select “CANCEL” and press it.

To Reset The No. Of Prints . . .

..... select “RESET” in step 5 on pg. 34. The number

of prints is reset to 0 for all still images.

CAUTION

While performing the above, never disconnect power, as this may cause the memory to be corrupted. For safety, all buttons including the Power Switch are disabled in step 6.

NOTES:

●“BATTERY LOW” appears if the battery remaining power is too low.

●If you load a memory card already set as shown above in a printer compatible with DPOF, it will make prints of the selected still images automatically.

●To print images recorded on a tape, first dub them to a memory card (
pg. 32).