JVC GR-FXM16, GR-FX11, GR-SX41 Automatic Editing to VCR, Editing cable and the audio/video cable

Rewind the tape in the camcorder to the beginning of the scene you want to edit and press PAUSE.

Original tape (camcorder)
	1			3	2
		IN	OUT	IN OUT	IN OUT

Edited tape (VCR)

Power Switch

Recording Start/Stop Button

MENU Button

PAUSE (6) Button

STOP (5) Button

REW (2) Button

Remote Sensor

RM-V700U (optional)

VCR REC STBY

ON/OFF

EN47

AUTOMATIC EDITING TO VCR

9

10 Point the remote control towards the VCR’s infrared sensor and press VCR REC STBY, or manually engage the VCR’s Record-Pause mode.

11 Press MENU on the camcorder to begin Automatic Editing, and the previously selected scenes are copied to the VCR in the specified order.

While editing, the R.A. Edit counter of the scene which is being copied is shown with a blinking highlight.

•Pressing START/STOP on the remote control does not start editing.

12 When all selected scenes have been copied, the camcorder and VCR enter the Still or Pause mode. Press STOP on both units. To make the R.A. Edit counter display disappear, press ON/OFF. •When finished editing, be sure to disconnect the

editing cable and the audio/video cable.

NOTES:

●If you performed step 1 on page 45 (“MAKE CON- NECTIONS”), keep the remote control pointed at the VCR during editing.

●The on-screen display only appears while the camcorder searches for each scene.

●There may be noise at in- or out-points on the edited tape with certain VCRs.