JVC GR-FX50 manual No power is supplied, Recording does not start, Animation or Time-Lapse is not

Page 48

48EN

TROUBLESHOOTING

If, after following the steps in the chart below, the problem still exists, please consult your JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery pack, AC Power Adapter/Battery Charger, etc.) and clock battery; and then re-connect it and proceed as usual from the beginning.

SYMPTOM		POSSIBLE CAUSE(S)
POWER
No power is supplied.		● The battery pack has not been attached correctly
		(☞ pg. 4).
		● The battery pack is not charged (☞ pg. 4).
		● The power supply has not been correctly connected
		(☞ pg. 5).

The power suddenly goes off and		● The battery pack has completely discharged.
does not come back on by itself.		● Remove the cassette and disconnect the power source, then
		after a few minutes, try turning the power back on. If it still
		does not come on, consult your nearest JVC dealer.

RECORDING
Recording cannot be performed.		● Make sure the Erase Protection tab is in the position that
		allows recording. If not, slide the tab. Some cassettes have
		removable tabs. If the tab has been removed, cover the
		hole with adhesive tape.

Recording does not start.		● The camcorder Power Switch has not been set to
		“CAMERA” (“AUTO“ or “PRO.“.) (☞ pg. 12).

Animation or Time-Lapse is not		● Before recording in the Animation mode at the very
available.		beginning of a tape, set the camcorder to the Recording
		mode for about 5 seconds, so that the tape runs smoothly.
		Using the Fade-in function at this point is a good way to
		begin an animated program. (☞ pg. 33, 41)

PLAYBACK
The tape is running, but there is no		● The TV has not been set to its VIDEO mode or channel.
playback picture.		● If A/V connection is used, the TV’s VIDEO/TV Switch has
		not been set to VIDEO.

Playback picture is blurred or		● The video heads are dirty or worn out. Consult your nearest
interrupted.		JVC dealer for head cleaning or replacement.

The counter indication is blurred		● This is normal.
during Still playback.

TAPE TRANSPORT
The tape stops during fast-forward or		● The Counter Memory Function has been activated
rewind.		(☞ pg. 36).

Rewinding or fast-forwarding cannot	● The tape is already fully wound on one reel or the other.
be performed.

Image 48

Contents GR-FX50 GR-FX40 GR-FX10 Dear Customer It is recommended that youMajor Features Contents EN3 Power Charging the Battery PackUsing the Battery Pack Using AC Power Using a CAR BatteryDischarged Clock Lithium Battery Insertion/Removal Switch OFF PowerRemove Battery Holder Insert Battery in HolderDate/Time Settings Recording Mode Setting Tape Length SettingSET Recording Mode ContLoading/Unloading a Cassette Open Cassette HolderINSERT/REMOVE Cassette Close Cassette HolderGrip Adjustment Viewfinder AdjustmentAdjust Length Shoulder Strap AttachmentTripod Mounting Attach StrapPower Switch Position Basic RecordingLoad a Cassette Start ShootingViewfinder Indications Stop RecordingPress Display Button RecordingEN Recording Basic Features Push the Power Zoom Lever towards TZoom Zoom OutFeature Quick Review To check the end of the last recordingBasic Features Feature Picture StabilizerPress P. STABILIZER. appears Feature 5Sec. Rec 5-sec. Recording Recording Basic Features Feature Video Light GR-FX50/FX40 onlyTo brighten the scene when natural lighting is too dim Recording Advanced Features EN19 Fade/WipeModeengage FADE- or WIPE-STANDBY Start or END RecordingAdvanced Features Select ModeProgramme AE With Special Effects Press P.AE to cycle through the modes as shown on the leftDisplay Mode Nega Posi modeHigh shutter speed clearly captures fast-moving action Colours of a picture are reversedRecording Advanced Features Date/Time InsertPress the Select Dial to display the Menu Screen Access Title Menu Select the Desired ModeInstant Titles Using Menu For Detailed Adjustment Make SettingEND Setting Menu Screen Available Using The Select Dial Menu Screen Available Using The Menu ButtonMenu Screen Explanations Tally lamp comes on to signal the start of recording Demo Mode is set to on and the Menu Screen is closedAllows you to set the current date and time pg Recording pgAccess Exposure Menu Access Manual ExposureAdjust Exposure END Adjustment of ExposureFocusing Auto FocusPatterns that are regularly repeated Access Focus Menu Access Manual FocusAdjust Focus END Adjustment of FocusWhite Balance Adjustment Access White Balance AdjustmentSET Function Parameters To Return To Automatic White BalanceEnter Setting Manual White Balance OperationSET Manual White Balance To Change The Tint For RecordingSelf-Timer Access INT. Time MenuStart Delayed Recording SET Interval TimeAnimation Time-LapsePlayback Basic Playback Rewind or Fast-Forward the tapePlay Back Stop PlaybackTracking Activate Manual TrackingNoise bars disappear Finishes, the indication disappearsPlayback Features Feature Still PlaybackFeature Shuttle Search Feature Counter Memory FunctionUsing The Cassette Adapter EN37 Insert BatteryCassette Adapter When connecting the cables, open this cover Basic Connections And Tape DubbingBasic Connections Connection For Tape DubbingTape Dubbing Installing The Battery Pull OUT Battery HolderRemote control uses one lithium battery CR2025 FunctionsFeature Self-Timer, Animation and Time-Lapse Self-TimerAnimation Time-LapseCreate edited videos easily using your camcorder as SET REMOTE/VCR CodeOperate VCR You are now ready to try Random Assemble EditingMake Connections JVC VCR Equipped with Remote Pause TerminalVCR Other than Type or Prepare CamcorderSelect Scenes Start Source PlaybackRegister END of Scene At the bottom of the screenAutomatic Editing to VCR Prepare Source TapeBegin Automatic Editing END Automatic EditingReset Counter Insert EditingFind EDIT-OUT Point Begin Insert EditingAudio Dubbing Begin Audio DubbingEND Audio Dubbing No power is supplied Recording does not startAnimation or Time-Lapse is not AvailableAn error number i.e. E03 appears Review or Retake modeDuring recording, the indications do not appear Tape will not eject50EN Dioptre Adjustment Control Lens Cover Open/Close Ring Video Light Switch Light OFF/AUTO/ONPower Switch Battery Release Switch Connectors w to r are located beneathIndex Indications For safety, do not To avoid hazardDuring use Store cassettesAvoid using the unit Cleaning The CamcorderDo not leave the unit To protect the unit, do notConnectors Provided Accessories Optional AccessoriesGeneral GR-FX10