JVC GR-FXM65 specifications 36 EN

36EN

RECORDING

AdvancedFeatures(cont.)

Menu Screen Available Using The MENU Button (cont.)

TELE MACRO	OFF	Usually the distance to a subject where the lens is in focus
	ON	depends on the zoom magnification. Unless there is a distance of
		more than 1m to the subject, the lens is out of focus at the
		maximum telephoto setting. When set to “ON”, you can shoot a
		subject as large as possible at a distance of approx. 60 cm.
		•Depending on the zoom position, the lens may go out of focus.
DATE/TIME	Allows you to set the current date and time (☞ pg. 11).
TAPE LENGTH*	Allows you to set the tape length depending on the tape used (☞ pg. 12).
PICTURE**	Allows you to select the image setting “FINE” or “STD” when storing in the
	camcorder’s memory (☞ pg. 22).
SNAPSHOT	FULL	Displayed with the System Select Switch set to either “VIDEO”
	PIN-UP	(☞ pg. 24) or “D.S.C.” (☞ pg. 21).
	MULTI-4	Displayed only with the System Select Switch set to “D.S.C.”
	MULTI-9	(☞ pg. 21).
	M.DRIVE
REC TIME*	This feature allows you to set the parameters for Animation and Time-Lapse
	recording (☞ pg. 43).
INT. TIME	This feature allows you to set the parameters for Self-Timer (☞ pg. 42) and Time-
	Lapse recording (☞ pg. 43).
TALLY LAMP*	OFF	The tally lamp remains off at all times.
	ON	The tally lamp comes on to signal the start of recording.
JLIP ID NO.	This number is necessary when connecting the camcorder to a device such as a computer
	using the J terminal (JLIP). The numbers range from 01 to 99. Factory setting is 06.
DEMO MODE*	OFF	Automatic demonstration will not take place.
	ON	Demonstrates certain functions such as Fade/Wipe, etc. When
		“DEMO MODE” is set to “ON” and the Menu Screen is closed,
		the demonstration starts.
		NOTES:
		● When a tape whose Erase Protection tab is in the position that
		allows recording is loaded in the camcorder, demonstration is
		not available.
		● By turning off the camcorder or inserting a tape whose Erase
		Protection tab is in the position that allows recording into it,
		“DEMO MODE” is set to “OFF” automatically.
		● During the demonstration, all functions except zoom are
		disabled.

*Activated only with the System Select Switch set to “VIDEO”. If the System Select Switch is set to “D.S.C.”, this function will not be activated although the highlight bar will move on the Menu Screen like the setting procedure.

**Activated only with the System Select Switch set to “D.S.C.”. If the System Select Switch is set to “VIDEO”, this function will not be activated although the highlight bar will move on the Menu Screen like the setting

procedure.

Functions listed without an asterisk are available with the System Select Switch set to either “D.S.C.” or “VIDEO”.

: Factory-preset