JVC GR-AXM38EG instruction manual Counter R/M, Tape Counter LCD monitor or viewfinder

NOTES:

RESET COUNTER

3 Press and hold COUNTER R/M for more than

1 second to reset the tape counter, then press again for less than 1 second and make sure “M” appears.

FIND EDIT-IN POINT

4 Press REW to go a little beyond the beginning of the scene you want to replace, press PLAY to view the recorded tape, and press PAUSE exactly at the point where the new scene should start.

ENGAGE INSERT EDITING MODE

5 Press and hold INSERT, and without releasing INSERT, press and release PAUSE. The Insert mode is engaged. When the scene the camcorder is aimed at appears on the screen, go to the next step.

BEGIN INSERT EDITING

6 Press START/STOP. When the counter reaches “0:00:00”, editing stops automatically and the camcorder enters the Insert-Pause mode.

END INSERT EDITING

7 Press STOP.

FIND EDIT-OUT POINT

Set the Power Switch to “PLAY”.

1

2 Play back the tape, locate the Edit-Out point and press PAUSE on the camcorder or the remote control.

Insert Editing

You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.

NOTE:

Use the RM-V700U remote control unit to perform this procedure.

SELECT MODE

USING REMOTE CONTROL UNIT

(cont.)

48EN

COUNTER R/M

	PLAY/PAUSE
REW	FF
STOP

Power Switch

Insert editing indicator

M–0:12:34

Tape Counter

LCD monitor or viewfinder

RM-V700U (provided)

START/STOP	● When Insert Editing is performed with the LCD monitor
REW
	fully opened, the original audio will be heard from the
PLAY	speaker.
PAUSE	● After step 5, Retake (☞ pg. 17) can be performed.
INSERT	● The tape may stop slightly before or after the desig-
	nated end point, and noise bars may appear. Neither
	indicates a defect in the unit.
	● Only video signal is recorded in the Insert Editing
	mode.