JVC GR-AXM4U manual Start/Stop, INT. Time +

NOTES:

Refer to pg. 35.

Press RECORDING START/STOP. Recording and intervals alternate automatically.

RELEASE TIME-LAPSE MODE

To release when the tally lamp is not blinking, press INT. TIME and REC TIME repeatedly until

“ ” and “ ” disappear. To release when the tally lamp is blinking, press RECORDING START/STOP to stop the blinking, then press INT. TIME and REC TIME repeatedly until “ ” and “ ” disappear, or set “Interval Timer” and “Rec Time” in the Sub Menu screen to “OFF”.

5

6

Press INT. TIME on the remote control. There are five choices available, and they appear in the following order (each time INT. TIME is pressed): OFF, 15S, 30S, 1 min, and 5 min. Pressing the button again will cancel the mode.

•You can also set the interval time in the Sub Menu screen. Press “–” to move the highlight bar down to “Interval Time”, press NEAR, and press + or – to cycle through the choices.

•Exposure control (☞ pg. 22), manual focusing (☞ pg. 25) and D.I.S. settings (☞ pg. 22) should be performed at this point. Once you perform step 5, these settings cannot be changed.

START TIME-LAPSE RECORDING

4

•You can also set the recording time in the Sub Menu screen. Press “–” to move the highlight bar down to “Rec Time”, and press NEAR, then press + or – to cycle through the choices.

SET INTERVAL BETWEEN RECORDINGS

SET RECORDING TIME

Set SP/EP to SP (☞ pg. 13).

SET RECORDING SPEED

Make sure the lens cover is open, then set the power switch to “CAMERA”.

1

2

3 Press REC TIME on the remote control. There are four choices available, and they appear in the following order (each time REC TIME is pressed): 1/4S, 1/2S, 1S, and 5S. Pressing the button again will cancel the mode.

Time-Lapse

You can record sequentially at preset time spans. Leaving the camcorder aimed at a specific subject, you can record subtle changes over an extended period of time.

ENGAGE RECORD–STANDBY MODE

36RECORDING

Interval Timer Indicator

Recording
	1min
Time Indicator	1 s

AdvancedFeatures(cont.)

Tally lamp

START/STOP

INT. TIME +

REC TIME

RM-V705U (provided)

MENU FAR – NEAR

LCD monitor or viewfinder

	Tele Macro	OFF
	Gain Up	AGC
	Color Filter	NOR .
	Tape Length	T30
	Title
	Date/Time
	Sub Menu
Main Menu Screen
	Tally	ON
	Interval Timer	OFF
	Rec Time	OFF
	JLIP ID NO .	07

Sub Menu Screen