JVC LYT1133-001A, GR-SXM195AS manual Connections To a TV/VCR, Tape Dubbing

Connections To A TV/VCR

1)Make sure all units are turned off.

2)Connect the camcorder to a TV or VCR. If using both TV and VCR, connect the VCR output to the TV input.

3)Turn on all units. Set the VCR to its AUX input

mode, and set the TV to its VIDEO mode.

•Use the AC Adapter as the power supply.

•The S-Video cable connection can improve the dubbed picture quality. A commercially available S-Video cable is required.

•Be sure to adjust the TV sound volume to its minimum level to avoid a sudden burst of sound when the camcorder is turned on.

•If you have a TV or speakers that are not specially shielded, do not place the speakers adjacent to the TV as interference will occur in the camcorder playback picture.

Tape Dubbing

1)Connect the camcorder and the VCR

(
“Connections To A TV/VCR”). Set the Power

Switch @ to “ ” while pressing down the Lock Button ! located on the switch, turn on the VCR’s power, and insert the appropriate cassettes in the camcorder and the VCR. Engage the VCR’s AUX and Record-Pause modes.

2)Press 4/6 ^ to find a spot just before the edit- in point. Once it is reached, press 4/6 ^ again.

3)Press 4/6 ^ and engage the VCR’s Record mode.

4)Engage the VCR’s Record-Pause mode and press 4/6 ^.

•Repeat steps 2) through 4) for additional editing, then stop the VCR and camcorder when finished.

To S-Video

Output 5

Connector cover

S-Video cable (commercially available)

White to

Audio

Output 6

Yellow to

Video

Output 7

A/V cable

To S-Video Input

TV

VCR

To TV or VCR

White to

Audio

Input

Yellow to

Video Input

15