Doorphone
Answering a call
When you receive a call from a door station, the main monitor station rings. You can monitor the visitor on the monitor display before answering a call.
1
2
3
Microphone
{MONITOR} | {PLAY} |
{MENU}
{DOOR KEY}
{TALK/OFF}
When a ringer tone is heard, press {TALK/OFF}.
L
appears on the display.
Speak to the visitor within 50 cm of the microphone.
LSpeak alternately with the visitor.
(If you and the visitor speak at the same time, you will not hear each other.)
To end the conversation, press {TALK/OFF}.
Note:
LIf you do not answer a door call within 30 seconds, the display will turn off.
A conversation will be automatically disconnected in about 90 seconds and then the display will turn off. LThe image taken by the door station is automatically recorded (page 14).
When using an additional door station:
LWhen you receive another call from the other door station during a conversation, see page 12.
Answering a call by voice sensor (Voice answer mode)
This mode allows you to answer a call by voice without pressing {TALK/OFF}. Voice answer must be set “ON” beforehand (page 21).
1 When a ringer tone is heard, answer with a clear voice such as “Yes?” or “Hello?”. LWhen a beep sounds, you can talk to the visitor.
Note:
LMake sure you are within about 50 cm of the main monitor station. LThe visitor cannot hear your initial reply when you answer with voice.
LYour initial reply should be brief (less than 1 second), otherwise the voice answer mode will not start.
LIf a visitor calls you, a loud, brief sound (such as a dog’s bark) may start the voice answer mode even though you have not replied by voice.
10
