JVC GR-SXM347UM No power is supplied, Recording cannot be performed, Recording does not start

Page 40

40ENTROUBLESHOOTING

If, after following the steps in the chart below, the problem still exists, please consult your JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery pack, AC Adapter, etc.); and then re-connect it and proceed as usual from the beginning.

SYMPTOM

POWER

No power is supplied.

POSSIBLE CAUSE(S)

●The battery pack has not been attached correctly (☞ pg. 6).

●The battery pack is not charged (☞ pg. 6).

●The power supply has not been correctly connected (☞ pg. 6, 7).

The power suddenly goes off and does not come back on by itself.

●The battery pack has completely discharged.

●Remove the cassette and disconnect the power source, then after a few minutes, try turning the power back on. If it still does not come on, consult your nearest JVC dealer.

RECORDING

Recording cannot be performed.

● Make sure the Erase Protection tab is in the position that

 

allows recording. If not, slide the tab. Some cassettes have

 

removable tabs. If the tab has been removed, cover the

 

hole with adhesive tape (☞ pg. 13).

 

 

Recording does not start.

● The camcorder Power Switch has not been set to “ ” or

 

“ ” (☞ pg. 14).

 

 

Animation or Time-Lapse is not

● Before recording in the Animation mode at the very

available.

beginning of a tape, set the camcorder to the Recording

 

mode for about 5 seconds, so that the tape runs smoothly.

 

Using the Fade-in function at this point is a good way to

 

begin an animated program (☞ pg. 26, 37).

 

 

PLAYBACK

 

The tape is running, but there is no

● The TV has not been set to its VIDEO mode or channel.

playback picture.

● If A/V connection is used, the TV’s VIDEO/TV Switch has

 

not been set to VIDEO.

 

 

Playback picture is blurred or

● The video heads are dirty or worn out. Consult your nearest

interrupted.

JVC dealer for head cleaning or replacement.

 

 

The counter indication is blurred

● This is normal.

during Still playback.

 

 

 

TAPE TRANSPORT

 

The tape stops during fast-forward or

● The Counter Memory Function has been activated

rewind.

(☞ pg. 31).

 

 

Rewinding or fast-forwarding cannot

● The tape is already fully wound on one reel or the other.

be performed.

 

Page 39 Page 41
Image 40
Page 39 Page 41
Contents GR-SXM747UM GR-SXM347UM GR-SXM247UM GR-SX877UM GR-AX777UM Dear Customer It is recommended that youImportant Safety Instructions Remote Control Unit Battery Pack RM-V715U GR-SXM747UM BN-V11UOnly Lens Cap AA R6 Battery Cassette AdapterHow To Attach The Lens Cap To Detach The Battery Pack Slide Battery Release and pull out the battery packApproximate recording time unit min Perform of Charging the Battery Pack pgUse the AC Adapter connect as shown in the illustration Grip Adjustment Tripod MountingDate/Time Settings Press the Menu Wheel in to close the Menu ScreenRecording Format Setting 10 ENRegular VHS VCR VHS VCR with Sqpb FunctionSqpb S-VHS Quasi Playback function Recording Mode Setting Tape Length SettingLoading/Unloading a Cassette 14 EN To Stop RecordingModels equipped with LCD monitor only Rotate the Bright Wheel until the brightEN15 Journalistic Shooting models equipped with LCD monitor onlyZoom 16 ENZoom Out GR-SXM247UM/SX877UM/AX777UM only Make sure the recording mode is set to SPPress the Recording Start/Stop Button to start If you press during Record-Standby 18 ENIf you press during Recording Fade/Wipe Effects Fades in/out to a black screen20 EN Program AE With Special EffectsDigital Effects Using Menus For Detailed Adjustment Press the Menu Wheel in. The normal screen reappearsRefer to Focusing pg Subject becomes slightly dark. This setting is suitable forAdjustment Allows you to superimpose one of eight preset titles pg24 EN Date/Time Insert EN25 1 Set the Power Switch toInstant Titles 26 EN AnimationTime-Lapse RETURN. Press the Menu Wheel in again toExposure Control 28 EN FocusingPatterns that are regularly repeated White Balance Adjustment Manual White Balance OperationPress the Menu Wheel in again to close the Menu Screen To Change The Tint For RecordingLoad a tape pg Set the Power Switch to 30 ENPlayback Features EN31 To cancel the effect, select OFF in stepUse optional S-Video and Audio cables Use optional Video and Audio cablesBasic Connections Power supply instead of the battery pack pgTape Dubbing 34 EN Cassette Adapter VHS PlaypakCover Slide the latch to open the adapter compartmentEN35 Functions ButtonsInstalling The Batteries 36 ENPlayback Zoom Animation And Time-LapseTo End Zoom Animation38 EN Insert EditingAudio Dubbing For Insert Editing and Audio DubbingNo power is supplied Recording cannot be performedRecording does not start Animation or Time-Lapse is notIndicators and the picture color An error number i.e. E03 appearsPower source That Date/Time setting is carried out42 EN Index Terms 44EN 3 4 5 t y # $ %Video Light Switch Light OFF/AUTO/ON Fade/Wipe Button FADE/WIPE Counter Reset/Memory ButtonEject Switch Power Switch OFFNight-Alive Indicator GR-SXM747UM SXM347UM only 46 ENIndications During Recording AX777UM onlyTape Running Indicator Playback Indications During PlaybackTape Counter Rewind/Shuttle Search Pause Audio DubbingTo prevent damage and prolong service life 48 ENUse only the following batteries To avoid hazardFor safety, do not Avoid using the unitDuring use Store cassettesTo prolong service life Cleaning The CamcorderTo prevent damage to the LCD monitor, do not After UseOptional Accessories ConnectorsGeneral GR-AX777UMGR-SX877UMGR-SXM247UMGR-SXM347UMGR-SXM747UM
Top Page Image Contents