JVC GR-SX877UM, GR-SXM347UM, GR-SXM247UM, GR-SXM747UM, GR-AX777UM specifications 42 EN

42EN

DETAILS

I T E M S	N O T E S
➪ Power	❍ Perform charging where the temperature is between 10°C and 35°C (50°F
(☞ pg. 6)	and 95°F). 20°C to 25°C (68°F to 77°F) is the ideal temperature range for
	charging. If the environment is too cold, charging may be incomplete.
	❍ Charging times are for a fully discharged battery pack.
	❍ Charging time varies according to the ambient temperature and the
	status of the battery pack.
	❍ To avoid interference with reception, do not use the AC Adapter near a
	radio.
	❍ Since the AC Adapter processes electricity internally, it becomes warm
	during use. Be sure to use it only in well-ventilated areas.
	❍ The following operation stops charging or discharging:
	•Set the Power Switch to “	”, “	” or “	”.
	•Disconnect the AC Adapter from the camcorder.
	•Unplug the AC Adapter’s power cord from the AC outlet.
	•Detach the battery from the camcorder.
➪ Date/Time	❍ The date/time cannot be stored in memory if the built-in clock battery
Settings	runs out. Consult an authorized JVC dealer for replacement, or set the
(☞ pg. 9)	date/time as necessary before you start shooting.
➪ Recording	❍ When the Power Switch is set to “		” or “	” and the LCD monitor is
(☞ pg. 14, 15)	opened at an angle of 60 degrees or more, the LCD monitor switches
	on and the viewfinder switches off automatically to save power
	(models equipped with LCD monitor only).
	❍ The cassette holder cannot be opened unless a power supply is attached.
	❍ There may be a delay after you slide EJECT until the cassette holder
	opens. Do not use force.
	❍ The time required to calculate the remaining tape length, and the accuracy of
	the calculation, may vary according to the type of tape used.
	❍ The tape remaining time indicator is correct only if the correct tape
	length has been selected (☞ pg. 12).
	❍ “TAPE END” appears when the tape reaches its end, and the power
	goes off automatically if left in this condition for 5 minutes.
	“TAPE END” also appears when a cassette whose tape is already at its
	end is loaded.
	❍ If the Recording Start/Stop button is pressed after the Record-Standby
	mode has continued for over 5 minutes, recording may not start
	immediately.
	❍ While shooting, sound is not heard from the speaker (models equipped
	with LCD monitor only).
➪ TBC	❍ The “TBC” indicator turns green (gray with a camcorder equipped with
(Time Base	a black/white viewfinder) while TBC is working.
Corrector)	❍ TBC does not work during still playback and shuttle search.
(☞ pg. 31)	❍ The “TBC” indicator turns white while TBC is not operative.
	❍ It may take a few seconds before TBC actually starts working.
	❍ The picture may be distorted if the TBC mode is activated or
	deactivated at the edit-in/-out points or when normal playback resumes
	after still playback or shuttle search.
	❍ If the playback picture is distorted when TBC is set to on, turn off TBC.