JVC GR-SX850 specifications For Insert Editing and Audio Dubbing

Press and hold A. DUB, and without releasing

A. DUB, press and release PAUSE. The Audio Dub- Standby mode is engaged.

Display
e4	Audio dubbing
M– 0 : 0 5 : 2 0	indicator
	During Audio
	Dubbing

Remote sensor

EN39

Audio Dubbing

You can record a new soundtrack on a prerecorded tape (normal audio only). The sound is recorded from the built- in microphone.

Perform steps 1, 2 and 3 of the Insert Editing procedure (☞ pg. 38) before continuing.

NOTE:

Use the RM-V700U remote control unit to perform the following procedures.

1 Press REW to go a little beyond the beginning of the scene onto which you want to dub the new audio, press PLAY to view the recorded tape, then press PAUSE at exactly the point where dubbing should start.

2

PLAY REW

Microphone

A.DUB

STOP

PAUSE

3 To begin Audio Dubbing, press PLAY. When the counter reaches “0:00:00”, Audio Dubbing stops automatically and the camcorder enters the Audio Dub-Standby mode.

4 To end Audio Dubbing, press STOP.

NOTES:

●Do not press FF or REW during Audio Dub-Standby, or the edit points will not be accurate.

●If the microphone is too close to the TV, or if the TV’s volume is too high, whistling or howling may occur.

RM-V700U

(optional)

NOTES

(for Insert Editing and Audio Dubbing):

●Insert Editing and Audio Dubbing may not work correctly if the tape contains blank segments, or if the recording speed was changed during the original recording.

●To edit/dub onto a tape, make sure the Erase Protection tab is in the position that allows recording. If not, slide the tab. Some cassettes have removable tabs. If the tab has been removed, cover the hole with adhesive tape.

●Do not press STOP during Insert Editing or Audio Dubbing, or the edit points will not be accurate.

●During Insert Editing and Audio Dubbing, when Insert- Pause or Audio Dub-Standby is engaged, the counter may go slightly past “0:00:00”. Recording, however, stops at exactly 0:00:00.