EN17
NOTES:
●The cassette holder cannot be opened unless a power supply is attached.
●There may be a delay after you slide EJECT until the cassette holder opens. Do not use force.
●The time required to calculate the remaining tape length, and the accuracy of the calculation, may vary according to the type of tape used.
●The tape remaining time indicator is correct only if the correct tape length has been selected (☞ pg. 12).
●“TAPE END” appears when the tape reaches its end, and the power goes off automatically if left in this condition for 5 minutes. “TAPE END” also appears when a cassette whose tape is already at its end is loaded.
●If the
●If the Recording Start/Stop button is pressed after the
●If you are recording on a cassette from the middle (such as when a tape is removed and
VIEWFINDER INDICATIONS
Press DISPLAY for more than 1 second to make the following indications appear/disappear from the camcorder’s display: cassette warning, tape remaining time, battery pack remaining power indicator and tape length indicator (☞ pg. 44, 45).
NOTE:
Even if the indications are off, the tape remaining time appears blinking when the tape is near its end, and the battery pack remaining power indicator appears blinking when the power is almost gone.