JVC LYT0152-001B manual Self-Timer, Engage SELF-TIMER Mode, Stop SELF-TIMER Recording

EN27

Self-Timer

Once the camcorder is set, the camcorder operator can become part of the scene in a more natural way adding the final touch to a memorable picture.

Display

Lock button

Power lamp

			P
			L
5S		Y	A
M	A	OFF

Power Dial

START/STOP button

When the START/STOP button is pressed, the tally lamp changes as shown below:

MANUAL

– – –

PAUSE

Self-Timer indication

After 15 sec.

MANUAL

REC

444

During recording

Begins blinking	´ Blinks quickly	´ Stops blinking
(Self-Timer starts)	(Self-Timer shooting	and stays on
	starts soon)	(Self-Timer

4 shooting starts)

After approx. 15 sec.

1 SELECT OPERATION MODE

Turn the Power Dial to “ ” while pressing down the lock button located on the dial.

2 PULL OUT VIEWFINDER

Pull out the viewfinder fully. The Self-Timer indication appears.

•The camcorder enters the Record-Standby mode.

3 ENGAGE SELF-TIMER MODE

Press START/STOP.

After 15 seconds, the beep sounds and recording begins.

4 STOP SELF-TIMER RECORDING

Press START/STOP.

•The camcorder re-enters Record-Standby mode.

5 END SELF-TIMER RECORDING

Set the Power Dial to the “ A ”, “ M ” or “OFF” position.

•When turning to “OFF”, it is not necessary to press down the lock button.

To Take A Snapshot In The Self-Timer Mode . . .

.... in step 3, press SNAPSHOT instead of

START/STOP. After 15 seconds, a 6-second still is recorded. After that, the camcorder enters the Record-Standby mode.