JVC LYT0002-0S4A manual Connection to a TV or VCR, Equipped with an S-VIDEO, And/or A/V input RCA

						EN 57
3	AC Power Adapter/Charger			Connection to a TV or VCR
				equipped with an S-VIDEO
				IN and/or A/V input (RCA
To DC				type) connectors
		To DC
input jack
		output jack
	DC cord
	Core filter
		Core filter		Remote sensor
		To S-VIDEO	S-VIDEO cable (provided)
			To S-VIDEO input jack
		output jack
					To
		To AUDIO input jacks (L/R)		Red	TV or VCR
				White
	To AUDIO			Yellow		VCR
				To VIDEO
	output jacks (L/R)		VIDEO/
				input jack
			AUDIO cable
	Red
			(provided)
	White
	Yellow	Core filter
	To VIDEO output jack		(connect when the S-VIDEO cable is not used)

1 CONNECT DOCKING STATION TO TV OR VCR

Connect as shown in the illustration 1, 2 or 3 (☞ pg. 56, 57).

If Using A VCR . . . go to step 2.

If not . . . go to step 3.

2 CONNECTINPUT VCR OUTPUT TO TV

Refer to your VCR’s instruction manual.

3 TURN ON POWER

4 SELECT TV’S VIDEO MODE

Set the TV to the channel or mode appropriate for video playback.

NOTES:

●When using the provided VIDEO/AUDIO cable (Docking Station to TV or VCR), DC cord, S- VIDEO cable or editing cable, make sure you connect the end of the cable with the core filter to the Docking Station. The core filter improves performance of equipment.

●If TV/VCR is equipped with only one audio connector, use a conversion plug (commercially available).

●Set the VIDEO OUT select switch of the cable adapter as required:

Y/C: When connecting to a TV or VCR which accepts Y/C signals and uses an S-VIDEO cable. CVBS: When connecting to a TV or VCR which does not accept Y/C signals and uses an audio/ video cable.

Using the remote control unit with the camcorder attached to the Docking Station

While the camcorder is attached to the Docking Station, the camcorder’s remote sensor does not function. Point the remote control at the sensor located on the Docking Station.