JVC LYT0002-0S4A manual EN TR Ouble Shooting

68EN TROUBLESHOOTING (Cont.)

SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION

11.Even though “GAIN UP” was set to “A”, scenes shot in dark places are not brightened.

11. •Depending on the light 11.

source, the 1/25 shutter	————
speed may be deactivated in
order to reduce the
shakiness in the picture.

12. Snapshot mode cannot be	12. •The Squeeze mode is	12. • Disengage the Squeeze
used.	selected.	mode (☞ pg. 31).
13. Although the SNAPSHOT	13. •"PHOTO FRAME" is set to	13. • Set “PHOTO FRAME” to
button is pressed, the	"OFF" in the system menu.	“ON” in the system menu
white border does not	•The Cinema mode is	(☞ pg. 35).
appear.	engaged, disabling the white	• Disengage the Cinema
	border.	mode (☞ pg. 31).
14. Digital Zoom doesn’t	14. •10X optical zoom is selected.	14. • Turn off the Video Echo
work.	•The Video Echo effect is	effect (☞ pg. 43).
	activated.	• Wait until the Picture Wipe
	•Picture Wipe or Dissolve	or Dissolve effects are
	are being used in a scene	completed (☞ pg. 38).
	transition.	• Change the setting of either
	•5-Second recording was	the System Menu or the
	done with the Power Dial	Power Dial (☞ pg. 34).
	set to “5S”, and with “5SD”	• Do not attempt to take a
	selected in the System Menu.	Snapshot when performing
	•Snapshot Dissolve was	Digital Zoom (☞ pg. 25).
	attempted during Digital
	Zoom.
15. P.AE/Effects and Fade/	15. •The Power Dial is set to	15. • Set the Power Dial to “ M ”
Wipe Effects don’t work.	“ A ”.	(☞ pg. 18).
	•The Power Dial is set to	• Change the setting of the
	“5S”.	Power Dial.
16. The Black & White Fader	16. •The Sepia or Monotone	16. • Turn off Sepia and
doesn’t work.	effects are activated.	Monotone (☞ pg. 42).
17. The Dissolve function	17. •P.AE/Effects Sepia,	17. • Turn off Sepia and
doesn’t work.	Monotone or Slow are	Monotone before adding
	activated.	Dissolve to a scene
	•The Squeeze mode is	transition (☞ pg. 42).
	selected.	• Make sure that the Squeeze
	•The previously selected	mode in the Recording
	P.AE/Effect was changed	Menu is set to “OFF”
	after the last selected scene	(☞ pg. 30).
	for editing was registered.	• Make sure you have
		selected the P.AE/Effects

you want before starting editing (☞ pg. 42).

18.Scene transition does not go as expected.

18. •When using “Picture Wipe/	18.
Dissolve” (☞ pg. 38) or
“Dissolves during 5 second
mode recording” (☞ pg. 28),
there is a delay of a fraction
of a second between the
previous record stop-point	————
and the Dissolve start-point.

This is normal, but this slight delay becomes especially noticeable when shooting fast-moving subject or during rapid panning.