Kenwood MZ-B3 Setting the clock to stamp the recorded time, Ways, Recording, On the clock display

Setting the clock to stamp the recorded time

To stamp the date and time on the MD when you record, you first need to set the clock. When you use the recorder for the first time or after a long period of disuse, charge the built-in battery for the clock after setting the clock (page 18).

=

+

CLOCK SET (	p
(on the	Battery
	compartment
bottom)
	(on the
	bottom)

1 Connect the power source. Install three size AA (LR6) batteries.

2 Press CLOCK SET on the bottom of the recorder.

Use a pointed object.

The digits of the year flash.

Year, month, and date

DATE AM

Current time

3 Enter the current year by pressing

=or +.

To change the digits rapidly, keep pressing =or +.

4 Press (.

The year is set and the digit of the month flashes.

DATE AM

5 Repeat steps 3 and 4 to enter the
			Various
current month, date, hour, and
minute.
When you press (to set the
minute, the clock starts operating.			ways
	DATE
			of
		PM
			recording
	DATE
		PM

If you make a mistake while setting the clock

Press p, and set the clock again from step 2. You can skip a step by pressing (.

On the clock display

∙To display the current time

When the recorder is not operating or while recording, press DISPLAY repeatedly until the current time appears in the display. The time indication disappears after 10 seconds.

∙To display the time in the 24-hour system While setting the clock, press DISPLAY. To display the time in the 12-hour system, press DISPLAY again.

Continue to next page m

17

SONY MZ-B3 (E) 3-798-610-22(1)