Viewfinder screen status displays
Switching the display mode
The display mode settings are switched on the VF DISPLAY screen.
1 Perform the menu operations (pages 70 to 72) to open the “VF DISPLAY” screen.
n< VF DISPLAY >
DISP CONDITION:NORMAL
DISP MODE | :3 |
VF OUT | :Y |
VF DTL | :2 |
ZEBRA1 DETECT :070% | |
ZEBRA2 DETECT :085% | |
ZEBRA2 | :STOP |
LOW LIGHT LVL :OFF
Setting the camera ID
The camera ID is set on the CAMERA ID screen.
Up to ten alphanumerics, symbols and spaces can be used.
<Note>
The camera ID is not displayed while the setting menu is displayed even if color bar signals are output.
1 Perform the menu operations (pages 70 to 72) to open the “CAMERA ID” screen.
n< CAMERA ID >
ID :
2 Turn the JOG dial button to move the arrow (cursor) to the “DISP MODE” item.
3 Press the JOG dial button, and set the desired display mode.
Turn the JOG dial button to select the display contents, and press the JOG dial button to enter the selection.
4 Press the MENU button to exit the menu operations.
The setting menu is cleared, and the display showing the unit’s current statuses appears at the top and bottom of the viewfinder screen.
Setting the marker displays
The center marker and safety zone marker displays are set on the VF MARKER screen.
1 Perform the menu operations (pages 70 to 72) to open the “VF MARKER” screen.
n< VF MARKER >
SAFETY ZONE | :3 |
CENTER MARK | :ON |
FRAME SIG | :4:3 |
MARK | :OFF |
LVL | :15 |
2 Turn the JOG dial button to move the arrow (cursor) to the ID item.
n< CAMERA ID >
m
ID :
3 When the JOG dial button is pressed, the arrow (cursor) flashes, and the input mode is established.
4 Turn the JOG dial button until the character to be set appears. When the button is turned, the character displayed is switched in the following sequence:
Space: ) 7
letters:
numbers:
7
symbols: ’, >, <, /, –
5 Press the JOG dial button to enter the character.
6 Turn the JOG dial button to move the arrow (cursor) to the next position (right), and repeat steps 3 to 5 to set the characters.
7 Press the MENU button to exit the menu operations.
The setting menu is cleared, and the display showing the unit’s current statuses appears at the top and bottom of the viewfinder screen.
2 Perform the same operations as for the “VF DISPLAY” screen to set each item.
<Note>
The camera ID is recorded at the same time as the color bar signals if “CAMERA ID” on the VF INDICATOR screen has been set to “ON.”
44