Panasonic WV-C L920A, WV-C L924A Select AWC →, Manual Fine Adjustment for AWC ATW

•Automatic White Balance Control Mode (AWC) In this mode, accurate white balance is obtained

within a color temperature range of approximately 2 300-10 000K.

1. Move the cursor to the WHITE BAL parameter and

select AWC →	PUSH SW.
	** CAM SET UP **
CAMERA ID		OFF	↵
ALC/ELC		ALC	↵
SHUTTER		OFF
AGC		ON(DNR-H)↵
SENS UP		OFF
SYNC		INT
WHITE BAL		AWC→ PUSH SW
MOTION DET		OFF
LENS DRIVE		DC
END	SET UP ENABLE

2.Press I to start the white balance setup. The PUSH SW is highlighted to indicate that the white balance is being set.

** CAM SET UP **
CAMERA ID		OFF	↵
ALC/ELC		ALC	↵
SHUTTER		OFF
AGC		ON(DNR-H)↵		Highlighted
SENS UP		OFF
SYNC		INT
WHITE BAL		AWC→	PUSH SW
MOTION DET		OFF
LENS DRIVE		DC
END	SET UP ENABLE

3.When the white balance setting is completed, the PUSH SW returns to normal display.

Note: In case that the white balance is not set, the PUSH SW is being highlighted.

4.When you want to adjust the white balance manual- ly, press M to select AWC and press I. The AWC menu appears on the monitor. (When ATW is selected, pressing I displays the ATW menu.)

	** CAM SET UP **			**	AWC		**
CAMERA ID		OFF	↵	R
ALC/ELC		ALC	↵			....I....
SHUTTER		OFF				-	+
AGC		ON(DNR-H)↵		B		....I....
SENS	UP	OFF			-		+
SYNC		INT		MASK SET
WHITE BAL		AWC	↵		↵
MOTION DET		OFF
LENS	DRIVE	DC
END	SET UP ENABLE			RET END

Manual Fine Adjustment for AWC (ATW)

You can set the white balance items manually.

1.To set MASK SET, proceed as described in steps 2 to 4 of “ALC mode with PRESET OFF” (See page 26 and 27).

2.Move the cursor to R.

3.Press L or M to obtain the optimum amount of red gain.

4.Move the cursor to B.

-36-