Panasonic TZ7, ZS3 user manual Mounting the camera in the housing

Page 6

4.5 Mounting the camera in the housing:

Replace the lid and make sure the lever is perpendicular to the side wall of the housing. Lock the lid by press down the lever and turn until the lever is parallel to the side wall of the housing.

After replacing and locking the lid, make a final visual inspection of the main O-ring for

contamination.

Note: If the O-ring is in good contact, a thin black line, about 0.5 to 1mm in width should be visible, where the O-ring is in contact with the lid. Follow this line all the way round the edge of the seal, as a final check that the seal is good

4.6 Mounting the camera lens and ports

The housing is now ready for the dive.

Important !!! Check the o-ring seal on the lid and should see an even and continuous pressed o-ring path of about 0.5 – 1 mm thick

6

Image 6
Contents Introduction Approximately 0.8 kg Housing only 115 x 150 x 110 mm LxWxHControl Details Special note on responsibility for watertight integrityWhen to maintain the O-ring seal ProcedureMaintaining the O-ring Seal Key Hole Lock Mounting the camera in the housing Cleaning & Storage Pre Dive Function CheckTransportation AccidentsPlease keep this document for future reference