•Clean the O-ring recess (the square groove where the O-ring sits) with a cotton bud.
•Inspect the O-ring all the way round its surface for damage such as cuts tears or contamination. This should be done visually and also by feeling the surface texture between finger and thumb.
•IF THE O-RING IS DAMAGED OR SUSPECTED OF BEING DAMAGED, DISCARD IT IMMEDIATELY.
A spare O-ring is supplied with your housing, or a replacement O-ring can be ordered from 10BAR. If the O-ring is contaminated or suspected of being contaminated, clean it with a cotton cloth that is free of all chemicals or contamination. After cleaning inspect the O-ring again.
Once the O-ring has been inspected and verified fit for use, apply a small amount of silicone grease to the O-ring. The silicone grease must be evenly distributed round the O-ring.
Replace the O-ring into the groove; run a finger round the O-ring, to make sure it is snugly seated in the groove.
4.4 Key Hole Lock
The Key -hole Lock is simple and easy to use and adding security.
Turn the levers of the lock perpendicular to the wall of the housing until the lock is released on
both sides.
Pull out the lid by holding on the grip near the lock